answersLogoWhite

0

What else can I help you with?

Related Questions

Where is the temperature sending unit on a 1977 302?

The temperature sending unit on a 1977 302 engine is on the front. It is located in front of and to the right of the intake manifold.


What are the torque specs for a 1977 Chevy small block 400 intake manifold?

45, for an iron intake, 35 for aluminum.


Where is egr valve located on 1976 ford 351 engine?

On my 1977 Ford 302 engine it was mounted on the back of a spacer between the carburetor and the intake manifold - underneath the air filter - I don't know if yours is the same


Where is the Temperature Sending Unit on a 1977 Chevy 305?

It's usually screwed into the intake manifold towards the front, near the thermostat housing.


What is the intake manifold torque pattern for a 1977 Chevy Blazer with a 305?

start with center bolts and work your way out in a circular patternaltenating from side to side


How can you add hp to your 1977 Chevy caprice 250 straight six?

To add horsepower to your 1977 Chevy Caprice with a 250 straight-six engine, consider upgrading the intake and exhaust systems. Installing a performance intake manifold and a free-flowing exhaust can improve air flow and engine efficiency. Additionally, tuning the carburetor or replacing it with a performance model can enhance fuel delivery. Lastly, upgrading ignition components, such as the spark plugs and distributor, can also contribute to better performance.


Where do you install the temp sending gauge on a 1977 Ford engine?

if v8 it is in water neck or right behind on intake mantifold /strait 6 water neck or intake on side moter


Will a 1989 throttle body intake from a 5.7l engine bolt on my 1977 400sbc?

Only if you also use the 89 cylinder heads.


When was A Sharp Intake of Breath created?

A Sharp Intake of Breath was created on 1977-07-28.


What actors and actresses appeared in Kikkassen - 1965?

The cast of Kikkassen - 1965 includes: Casper Christensen as (1977) Bob Goldenbaum as Lillebror (1966-1977) Ingrid Skovgaard as Ingrid (1966-1977)


What could be causing weak brakes on a 1977 Ford F-350 one ton truck I have changed master cylinder twice brake booster 4 times replaced brakes calipers and brake shoes replaced brake hoses help?

Try checking the vacuum hose from the booster to the intake manifold for cracks (ie. leaks). A can of carb cleaner lightly misted over the hose if there is a leak/crack will make the engine idle higher(Warning! Do while the engine is still fairly cool!). The same goes for the connection at the intake manifold itself. Also if the engine is underperforming (ie. running badly) this will also produce weak brakes (too little vacuum). And finally, if the engine idle is set too high it will also produce weak brakes(too little vacuum).


How do you pull a distributor on a Chevy 1977 pickup 350?

One bolt at the rear of the intake manifold holds a clamp that is shaped like a Y. Remove the bolt, take the clamp off and slightly twist or rock the distributor back and forth and lift it straight up.