0
What else can I help you with?
1996 Chevrolet c1500 pickup truck bolt torque specifications for 5.0L intake manifold?
1996 chevy c1500 pick up 305 motor bolt torque spec intake manifold
What is the torque specs for 96 Chevy beretta z26 3.1?
Lower intake manifold bolt 115 in/lb. Upper intake manifold bolt 18 ft/.
Can you switch a carburetor from a 305 Chevy to a 350 on 1985 c 10?
First of all the 85 is a fuel injected engine, You can not put a carburetor on a fuel injected intake manifold it won't even fit.And if you put a carbureted intake on it you will need to change the elect fuel pump in the tank, the distributor and you will need to DRILL out the 4 center bolt holes in the intake manifold too. Plane and simple THE ENGINE WON'T RUN WORTH A...................D...M need to keep it fuel injected.
How do you change a fuel injected engine to carburated?
You have to get a special intake that you can bolt a carburetor to.
What is bolt torque for lower intake manifold for 97 buick lesabre?
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
Can you put 98 vortec 350 heads on a 350 tbi motor?
yes they will bolt on to the block. valve train will be the same. valve covers will be the same. but you will have to buy a different intake manifold. the bolt pattern and gaskets for the intake is different. there are aftermarket parts available for this swap
Where is the camshaft sensor located at on a 2004 ford escort?
On the intake side of the head just below the intake manifold. The intake manifold has to come off to get to it. It's held in with just one bolt.
What are torque specs for head gasket and intake manifold for 1999 Pontiac sunfire?
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
1992 Chevy pick up its TBI and you like to chang it to carburetor will an old 1970 intake manifold fit in the 1992 305 motor?
No it will not unless you modify the intake bolt holes, They don't line up with the late model heads.
Can you show a pic of where the bolts for the intake manifold are on the ford expedition 2000?
Here is a link that shows how to replace the intake manifold gasket. Bolt locations and torque settings. Hope this helps.
Will the intake off a 97 350 motor fit on a 88 motor?
No it will not. The bolt patteren is different on the intake and heads. Won't work.
What is the intake manifold bolt torque on a 94 Chevy 5.7L V8?
30 ft pounds
