yes i just put one on my 2001 400ex the only thing you really have to do is take the intake manifold and hoen it out some the intake tube is a tite fit but it works
no they dont have reverse unlil 2005
GN4 Honda oil only.
2.6 quarts
2.6 Quarts
10w-40 G4
It depends what year it is. The 1999-2004 did not have reverse but on the 2005 and newer there is a switch on the right fender.
The stock spark plug is the NGK DPR8Z gapped at 24 to 28.
To remove the carburetor from a 2005 Honda TRX 450R, first, ensure the engine is cool and disconnect the battery. Remove the air filter and intake boot clamps to access the carburetor. Then, disconnect the fuel line and throttle cable, followed by the choke cable if applicable. Finally, unbolt the carburetor from the engine and carefully lift it out.
A 2005 Honda Shadow 750 has an actual engine size of 745cc. depending on the carburetor type the bike has either 43 or 47.2 horsepower.
To remove the carburetor from a 2005 Honda Rincon 650, first, ensure the engine is off and cool. Disconnect the battery, then remove the air intake duct and any necessary covers to access the carburetor. Detach the fuel line, throttle cable, and any electrical connections, then unbolt the carburetor from the engine. Carefully pull it out, ensuring not to damage any surrounding components.
To clean the carburetor on a 2005 Honda TRX450R , you will need a Philips head screw driver and carburetor cleaner along with patients. Follow these simple instructions: Remove the front plastics, fuel tank and take shroud. Using a Philips head screwdriver, remove the two brackets. Then remove the carburetor and the float on the bottom. Remove the jets and either spray or soak in carburetor cleaner. Hint: if you see daylight through the jets, they are clean.
To clean the carburetor on a 2005 Honda Rincon 650, first ensure the engine is cool and disconnect the battery. Remove the carburetor from the engine by detaching the air intake and fuel lines. Disassemble the carburetor carefully, then soak the parts in a carburetor cleaner solution, using brushes to clean out jets and passages. Rinse the components, dry them thoroughly, and reassemble the carburetor before reinstalling it on the ATV.