0
What else can I help you with?
Will changing the gear ratio from 373 to 410 affect the speedometer and tachometer readings in a 2003 Chevy extreme with a 4.3 liter engine?
It will affect the speedometer but the tachometer will still be accurate.
How do you change the speedometer gear on a 4x4 88 Comanche for bigger tires?
To change the speedometer gear on a 1988 Jeep Comanche with 4x4 for bigger tires, first, determine the correct gear ratio based on your new tire size. Remove the speedometer cable from the transfer case, then unbolt and remove the speedometer gear housing. Replace the existing gear with one that matches your new tire size and reinstall the housing and speedometer cable. Finally, test the speedometer to ensure it's accurate.
How do you recalibrate a speedometer?
Speedometer calibration differs depending on the vehicle and age. Some cars are calibrated by a technician with a computer program. Others require a gear change to drive the speedometer at a different ratio.
Where is the speedometer gear located on a s1700 SCHOOL BUS?
If it's old enough to have a mechanical speedometer, it'll be in the speedometer itself. If it has an electronic speedometer, there is no speedometer gear - to recalibrate the speedometer to match something like, say, changing tire size would require changing the parameters in the engine ECM.
What color speedometer gear for 3.08 ratio?
For a vehicle with a 3.08 axle ratio, the speedometer gear color typically depends on the specific transmission and tire size used. Generally, a green or yellow speedometer gear is common for this ratio, but it's important to verify with the vehicle's service manual or a trusted source to ensure accuracy. Always consider the exact specifications of your vehicle to get the correct gear.
Will a speedometer cluster from a 1991 freightliner fld120 interchange with a 1994 freightliner fld120 classic speedometer cluster?
The Classic was the FLD132, and no. For one, the speedometer is set according to the gear ratio, tire size, and rear end gear ratio of the truck, and if those vary, the speed won't be accurate.
How do you change a speedometer on a 1993 Grand Cherokee Laredo?
did you check the speedometer gear in the tranny?
Can a carburetor change a car gear ratio?
no, the carburetor has nothing to do with your gear ratio.
Can you switch just the ring gear or do you need to change the ring and pinion both when changing ratio like from a 3.23 to a 3.50?
When changing the gear ratio from 3.23 to 3.50, you must replace both the ring gear and the pinion gear. The ring and pinion gears are designed to work together as a matched set, and using them separately can lead to improper meshing, increased wear, and potential failure. Therefore, for optimal performance and reliability, it's essential to change both components when altering the gear ratio.
Could you put a smaller tire on your car?
You could, but you'd have to adjust your speedometer, and you'd also have to change your gear ratio if you wanted to maintain similar performance to what you had already.
What can you do to calibrate your speedometer rear end was switched from stock in your 97 Firebird formula to a 373 out of a 2000 trans am?
To calibrate your speedometer after switching the rear end to a 3.73 gear in your 1997 Firebird Formula, you'll need to adjust the speedometer gear or use a tuning tool if your vehicle is equipped with an electronic speedometer. If using a mechanical speedometer, replace the speedometer gear with one that corresponds to the new gear ratio. For electronic systems, you may need a handheld tuner or a reprogramming tool to adjust the speedometer settings according to the new rear-end ratio. Always verify the calibration by comparing the speedometer reading to a GPS or radar speed measurement.
How do you change gear ratio?
You have to change the gears
