I assume you have a '98-'03 model with stock springs. If you have changed your springs for aftermarket products, the below specifications do not apply.
Use either of two methods:
A) measure 465 ml per fork leg
B) measure 132 mm air gap (room from the surface of the oil to the top of the fork without the springs and with the fork fully compressed)
Note 1: It is very important to have the numbers correct and - even more important - the same at both sides. If you miss out on this, it may result in poor handling and even have disastrous consequences.
Note 2: Measuring air gap is recommended over measuring volume, and not especially more difficult, it will be more precise and yield better results. You can use any measuring device dropped in at the desired length and fill until the oil slightly touches OR you can overfill and suck out the excess oil with a hose that you drop in at the specified depth.
Note 3: Recommended oil is a grade 10W fork oil.
Addendum: You can tweak you forks according to your liking, e.g. by putting 15W grade fork oil in or reducing the air gap by a few millimeters. But make sure you know what you or doing, If you do not understand the impact of these changes just follow the recommendations.
Succes!
352cc of 10wt fork oiul
3.7
qt fork oil and type oil for the front fork on each side
According to the Yamaha Service Manual 17.6 US oz/18.3 Imp oz per fork is the standard capacity.
Each front fork holds: 400cm3 or 14.1 oz or 13.5 US oz.
I think 1L to 1.5L will be the quantity.
For the 2000 Yamaha DT175, each fork leg typically requires about 400cc (or 400ml) of fork oil. It's important to check the owner's manual or service manual for your specific model for any variations. Additionally, ensure you use the recommended type and viscosity of fork oil for optimal performance.
The 1985 Yamaha XJ700 Maxim requires approximately 10.6 ounces (or about 315 milliliters) of fork oil per fork leg. It's important to use the manufacturer's recommended fork oil type and viscosity, typically 10W for this model. Always refer to the service manual for specific guidelines on maintenance and oil levels.
7.8 oz. of 10wt fork oil
There isn't an 850 venture. Only a 1200 and 1300.
I have a Yamaha 2006 wr250f 4 stroke and I need to know how much front fork fluid goes in each side. either by cc or oz's, so any help would be greatly appreciated. Thank you, Lori
For a 1985 Yamaha Virago 1000, each fork typically requires about 10.5 ounces (or approximately 310 milliliters) of fork oil. It's important to check the specific service manual for your model, as variations may exist based on modifications or maintenance history. Always ensure to use the correct viscosity oil recommended for your bike.