You need to get the trans fluid changed immediatley
Change oil and filter
go to a mechanic immediately
did u put a little bit or alot? if its a little use a turkey baster to suck it out
The first thing you should do is remove the master cylinder so you can dump the brake fluid reservoir out. If you have used the brakes, it is a very good idea to get the entire brake system bled and replace all the brake fluid.
Do not pump the brakes. You will need to get all of the contaminated fluid out and refill the master cylinder.
doesnt matter they work in either you are ok just dont doit unless emergency
The resivoir is built into the transmission.
Have it cleaned out and flushed immediately
Engine oil reservoir, differential, radiator, power steering reservoir, brake fluid reservoir, windshield washer fluid reservoir, transmission or clutch.
Then you need to "accidentally" remove it ... pronto, which may mean flushing out the entire coolant system if the engine has been run.
In a Toyota forklift, the brake fluid is typically poured into the brake fluid reservoir, which is usually located near the back of the engine compartment or near the driver's seat. The reservoir is usually a clear plastic container with a cap labeled for brake fluid. Always ensure the forklift is on a level surface and that you use the recommended brake fluid type specified in the owner's manual. Regularly check the fluid level and top it off as needed to maintain proper brake function.
You sir are an idiot.