answersLogoWhite

0

it could be your driveshaft. I'd get it looked at if i vvere you.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What would cause your 1998 Dodge Ram 1500 to make a repetative clunking sound when you drive in four wheel drive only?

Check for looseness in the front axle u-joints.


Tapping nose and oil gauge don't move?

Check the oil level, if it is full, you got problems, don't drive it.


How near is Tapping in Perth WA to Toodyay Perth WA?

not too far, about a 40 min drive. or you can get the train from joondalup


What causes a repetative clunking and grinding noise when the four wheel drive is engaged in a 1998 dodge ram half ton?

Depends on which part of the truck the noise is coming from. Could be an u-joint, a wheel bearing, a failed transfer case......


Does small 120 gig hard drive vs large 1 ter hard drive affect PC speed?

The capacity of the hard drive has no bearing on performance. The rotational speed of the drive, as well as the size of it's cache, however, do often have a noticeable impact.


What does taping on the starter do?

Tapping the starter is an old fix and usually doesn't work any more. It was done to free up a stuck starter drive.


What is the loud tapping and or knocking noise under the hood when the car is started and shakes when you drive it?

Serious engine knock or valve train noise. Have this looked into by a pro.


How long can you drive a vehicle when the rear end is making sound?

To the end of your drive.


What are the release dates for The Making of 'Test Drive' - 2002 - TV?

The Making of 'Test Drive' - 2002 - TV was released on: USA: 9 September 2002


Why would a 2000 Windstar make tapping sounds when the car is in drive or reverse you don't hear them when it idles and the oil is not low?

ours was making a teerrible knocking noise like it was low on oil. also the check engine light was stuck on. had a shop replace some gaskets (upper manifold maybe?) and noise is gone.


What are the best practices for using self-tapping screws in wood projects?

When using self-tapping screws in wood projects, it is important to pre-drill holes to prevent splitting, choose the right size and type of screw for the wood, and drive the screws straight and at the correct depth to ensure a secure and durable connection.


Why is there is a tapping sound coming from your fiat punto engine and it increasing as you increase speed what could it be?

The noise has been coming from the engine for the past week and I have been told it might be the oil pump not providing oil to the sump. The tapping sound comes from the engine and increases when i change into a higher gear and drive faster. Please help!