0
What else can I help you with?
How do you brake safely with hand brakes?
You would push down on both the front brake and the back brake. You would want to put a little more pressure on the back brake and slowly add pressure to the front brake. If you slam on the front brakes there is a possibility that you will fly over the handle bars. I know from experience and it is not fun. I hope this helped.
What is causing the parking brake light to turn on and beep and stay on while moving when the parking brake is not applied?
THE CAR NEEDS FRONT BRAKES............................
Does releasing pressure from the brake pedal result in a shift of weight to the front?
Yes, releasing pressure from the brake pedal can result in a shift of weight to the front of the vehicle. When the brakes are applied, weight is transferred to the front wheels due to inertia. When the brakes are released, this weight transfer is reversed, causing the vehicle's weight to shift back towards the rear. This dynamic is particularly noticeable during deceleration and acceleration phases in a vehicle's movement.
When the brakes are applied a vibration comes from the front of a vehicle with a disc drum system what could be the cause?
brake caliber
What causes a 1995 Chevy tracker to make a groaning or a squealing noise at the front rotor brakes during a stop?
When the brake pads are worn the rivets will actually touch the brake rotor when the brakes are applied. The brakes should be changed immediately.
Which lights are the brake lights and which lights are the fog lights?
Fog lights are in the front; they are commonly referred to as "brights" because they are the brighter of the two standard headlights. Brake lights are in the rear; they light up when pressure is applied to the brakes or when the car is in park or reverse.
What does the Brake warning light 1992 Chevy Silverado mean?
It means there is a pressure difference between the front and rear brakes when the brake pedal is depressed. It will not reset until the pressure difference is repaired or eliminated. Check for low fluid/ air, rear brakes adjustment or bad. Front brakes bad, Bad master cylinder internally leaking pressure, etc.
1988 Dodge Dakota there are two rear brake lines that lead to a valve in front of the left rear wheel then a single line to the rear brakes what is this valve?
It is a Proportioning valve. It controls how much pressure is applied to the brakes on each axle. During heavy braking this prevents rear brake lock-up.
What is a brake compensator?
a brake compensator aka proportioning valve.do to the fact that the front brakes useually do 70 percent of the stopping the compensator reduces the pressure of the brake fluid from the master cylinder to the rear brakes being they need less hydraulic pressure to stop. it also acts as a saftey valve in case a brake hose or line bursts, it will let to brakes retain pressure for emergency stop
What is brake compensation?
a brake compensator aka proportioning valve.do to the fact that the front brakes useually do 70 percent of the stopping the compensator reduces the pressure of the brake fluid from the master cylinder to the rear brakes being they need less hydraulic pressure to stop. it also acts as a saftey valve in case a brake hose or line bursts, it will let to brakes retain pressure for emergency stop
Spongy brakes on 1990 ford ranger?
May have air in the system and have to be bled Check the flexible brake lines (front) to make sure they are not ruptured and are ballooning when brakes are applied
Steering wheel shakes at high speeds when brakes are applied?
This is usually a symptom of excessive run-out (warped) on front brake rotor or rotors.
