Could be a bad ignition switch if it tries to start but will not start all the way once you release the key.
Check the floats in the carb and the butterflies, make sure they care clean and working, change the fuel filter because a clogged one will not work, and check all plugs wires roter and cap
To find a check relay for a 1984 Mazda B2000, you can start by checking local auto parts stores like AutoZone or O'Reilly Auto Parts. Additionally, online retailers such as RockAuto, eBay, or Amazon may have the parts you need. For more specialized or hard-to-find components, consider visiting a Mazda dealership or searching through salvage yards for used parts.
When that happened to me it was the sensor to the air filter. I had to replace the air filter and sensor.
Not getting fuel or spark?
Start with replacing the fuel filter and air filter.
start by disconneting the fuel filter on the engine side then turn the key if there is no fuel getting through then it is a clogged filter. if tht is not the problem then your screwed. start by disconneting the fuel filter on the engine side then turn the key if there is no fuel getting through then it is a clogged filter. if tht is not the problem then your screwed.
check all your fuses and battery connections?
is the fuel filter istalled correctly in from fuel line out to engine. PS won't be the first person to install it backwards
Yes, you should bleed the brakes on a 1986 Mazda B2000 if you notice a spongy brake pedal, after replacing brake components, or if air has entered the brake lines. To bleed the brakes, start with the wheel farthest from the master cylinder and work your way to the closest. Use a helper to pump the brake pedal while you open and close the bleeder valve on each brake caliper or wheel cylinder. Make sure to keep the master cylinder topped off with brake fluid throughout the process.
Yes, I clogged fuel filter will prevent fuel from getting to the engine.
It is wired inline with the Crank wire going from the ignition to the starter solenoid located on the starter. Clutch up --> open switch (no start); Clutch down --> closed switch (start) Very basic for this year of truck.
Mazda Lantis does not start