The wires that attach to the connector that attaches to the vehicle speed sensor.
When you cut the wires on your speed sensor there will be several of fax. The most notable affect will be the malfunction of your speedometer.
On the top rear of the transmission is a wire connector with 2 wires. That's the speed sensor. On the top rear of the transmission is a wire connector with 2 wires. That's the speed sensor.
The speed sensor, on your Nissan, has a black cable. The speed sensor does not actually have any wires. The cable goes to the speedometer.
The speed sensor is mounted in the top of the rear differential on a 1999 F150. Remove the wires, then unbolt the sensor to remove it.
It is located in the wheel hub. If the speed sensor fails, you have to replace the hub.If you have an ABS light coming on and the ABS computer says the speed sensor, don't rule out the wires as we had our speed sensor wires break. They were so thin that they couldn't even be soldered, so it is not surprising that they could break.
if your code is po500 check the wires between speed sensor and cluster .mostlikely your problem is in the cluster
The speed sensor is usually found on the transmission mounted at the top and it has 2 or 3 wires comming out with a connector at the end.
The circuit is the two wires that run from the TCM to the output speed sensor.
The speed sensor for a 1999 Chevrolet Cavalier is located on the side of the transmission. It has two wires coming out of it.
Hi Your output speed sensor is on the left of the gearbox right at the back it has two wires coming out of it.
grey and grey/red (pin1&6)
The input and output speed sensors are located on the front of the trans. They have two wires and the input sensor is closer to the engine.