0
flick your key on and off 3 times really fast the gauge cluster will read codes starting with a p write down the codes and look them up also you can temporarily get rid of the check engine light by disconnecting the negative battery cable and turning your key a couples times with the battery still disconnected this will get rid of the light for about a day or so but the problem causing the check engine light will need to be fixed to get it to go away permanantly....
What else can I help you with?
Will 2000 dodge neon engine fit in 1995 dodge neon?
(possibley) but most likey NO
Do you have to reset check engine light after you replace valve cover gasket on a 2000 dodge neon?
If the light is on, it will need checked and diagnosed.
What does the engine block light indicates on a Dodge Neon?
That is the check engine light.
Can you put a 2000 dodge stratus engine into a 2006 dodge neon?
No, it will not interchange.
Will an engine from a 2003-2005 Dodge Neon fit a 2000 Dodge Neon?
yes it will, only a few mods will need to be done
Can you put a 2001 Dodge Neon Engine in to a 2000 Dodge neon?
Yes there is no difference in the two years 2001 was a carry over from 2001.
Will a 2001 dodge neon motor work in a 2000 neon?
no a 2001 dodge neon motor will not work in a 2000 neon
Will a 2004 dodge neon engine work in a 2001 dodge neon?
No, The neon was revamped in 2003, with updated engines and chassis changes. As a Chrysler mechanic, the 2000 dodge neon 2.4L DOHC is the best. That will fit in a 2001 also.
Will engine light come on in 2000 dodge neon when need coolant?
no the light will not come on. i thought the same thing until i was almost right empty. i found that out when it over heated
Can you used the same key to the engine and trunk on a 2000 dodge neon?
YesYes
How to pass inspection with a check engine light on in a 2001 dodge neon?
You will need to get the cause of the check engine light repaired.
How do you turn off a check engine light for a 2000 dodge neon?
I have a 2004 Neon and I turn it off by disconnecting the positive battery cable and then turning the ignition key to the "On" position and hold it there for 1 minute.
