Need to get a pressure tester for rad. Do not pump up over 10LBS. And then look at the rear corners of the intake real close for leaks. The vortec engines are none for intakes leaking antifreeze. BE SURE TO CHECK ENGINE OIL CLOSELY FOR ANTIFREEZE
long life
how do you set valve on 1998 350 vortec
No, the 350 Vortec was not available until a couple years later.
No, the 1992 Chevy 350 (5.7L) V8 is not a Vortec engine.
A 5.7 is a 350. Vortec is basically the type of head used.
Probably a gasket leak. Could be the intake gaskets or the thermostat gasket.
a 350 will produce around 250 hp, and a 305 about 200 hp
A vortec 350 has a two piece intake manifold, with the upper portion being plastic.
It would trash the engine bearings real quick. Antifreeze in the oil is a for sure engine getter. I just got done rebuilding a 98 350 vortec that had antifreeze in the oil do to the intake gasket leaking and all the engine bearings were trashed.
There is a freeze out plug behind it that seals the water jacket up. REPLACE freeze plug.
YES, The 350 Vortec does. It is in the back top side of the engine. All the plug wires go to it.
The 1995 350 or 5.7L has a T.B.I. and standard heads. 1996 its a C.P.I. and Vortec heads.