Yes it can. Make sure first, that both surfaces are clean and de-greased by washing with a little lacquer thinner or similar.
You can replace a rearview mirror, on your 1996 Infiniti, by removing the old mirror with a scraper. Apply the glue to the cleaned surface. Hold the new mirror in place until the glue dries.
Gorilla Super Glue can hold up to 30 pounds of weight.
get a good hold and turn the handle where the mirror sits on. should be a quarter or half a turn. Please note: 'don't turn mirror' as it is build to swivel.
You have to use glue of course and you need someone to hold it together while you glue it
super glue.
IF its glued 2 the window u need 2 get a kit that has primer & glue JUST 4 rear veiw mirrows.The metal base needs 2 b cleaned very good & the window.Then apply the glue & hold 4 1 minute-U might want 2 mark where the mirror goes on the outside with a caryon so as where 2 put it.
super glue lad:)ANS 2 - It depends on WHAT it's holding ! -For a superb 'hold' the glue must be compatible to the material.Contrary to popular opinion, 'super glue' is NOT always the best choice.
To effectively use mirror glue to attach a mirror to wood, follow these steps: Clean the wood surface and the back of the mirror to remove any dirt or debris. Apply a thin, even layer of mirror glue to the back of the mirror. Press the mirror firmly onto the wood surface and hold it in place for the recommended drying time. Allow the glue to fully cure before moving or hanging the mirror. Follow the manufacturer's instructions for best results.
To change your GMC Suburban's rearview mirror from Celsius to Fahrenheit, locate the controls on the mirror that adjust the display settings. Press and hold the buttons until you see the option to switch between Celsius and Fahrenheit, then select Fahrenheit to make the change. If you can't find the controls on the mirror, refer to the owner's manual for specific instructions.
To effectively attach a mirror to a wall using glue, first ensure the wall and mirror are clean and dry. Apply a strong adhesive specifically designed for mirrors in small dots or lines on the back of the mirror. Press the mirror firmly against the wall and hold it in place for the recommended drying time. Avoid moving the mirror until the glue has fully cured to ensure a secure attachment.
To fix a porcelain chip using super glue, first clean the area thoroughly. Apply a small amount of super glue to the chip and press it firmly into place. Hold it in position until the glue sets. Sand down any excess glue for a smooth finish.
Super Glue or duct tape