answersLogoWhite

0

What else can I help you with?

Related Questions

How do you remove timing gear on 94 dodge 2.5?

There is a special tool ( a puller ) to remove the crankshaft sprocket.There is a special tool ( a puller ) to remove the crankshaft sprocket.


Do you need special tools to remove the crankshaft damper pulley on a 1998 Monte Carlo?

you just need a puller to take it off, it's not a special puller.


How do you pull off a crankshaft pully on an 95 Toyota camery?

You need a special puller. You can lease it in AutoZone.


Where is the crankshaft sensor on 1995 buick regal 3.8l and how do you change it?

The crankshaft sensor is located behind the harmonic balacer. you will need a puller with special bolts to remove the balancer.


How do you get a stuck crankshaft pulley off i have the bolt out it is stuck on there and will not budge?

It takes a special puller to remove the balancer. Advance auto parts stores will loan it to you. It is called a harmonic balancer puller.


How do you remove a crankshaft pulley on a 1995 dodge neon?

Your going to need to get a special puller if its rusted on, usually if its new or not rusty you can just remove the bolt and hit it with a hammer a few times and it will come right off but if it is rusted then you should get a crankshaft dampner puller


Do you need special tools to remove the crankshaft damper pulley on a 1996 Mitsubishi Eclipse?

on the Chrysler engine (420a) you do need a puller and installer to deal with the crankshaft dampener pulley.


How do you remove the crankshaft pulley on a Chrysler PT Cruiser?

With an special tool inserted in place of the bolt and a 3 jaw puller.With an special tool inserted in place of the bolt and a 3 jaw puller.


Removing crankshaft pulley on a 98 Plymouth breeze?

You need a special harmonic damper puller. It's a variant of a basic 3-jaw puller that it made stronger so that it wont break.


How do you replace a oil pump in a 2004 dodge stratus?

i think it is attached to crank shaft behind it's sprocket. I took 4 screws that attache oil pump to engine but it wont come out cause crankshaft sprocket is in the way. do i have to pull the sprocket with 3 jaw puller? seems like I can't find any useful info.Waynes manual skips this step :(


How do you remove the crankshaft pulley on a 2002 Chrysler PT Cruiser?

It requires a three jaw puller and a special tool that is inserted in place of the bolt.


Where can I find a Crankshaft Gear Puller?

any tools or auto store