No they don't.
Fog lights are in the front; they are commonly referred to as "brights" because they are the brighter of the two standard headlights. Brake lights are in the rear; they light up when pressure is applied to the brakes or when the car is in park or reverse.
I just had this problem. It turns out there's a plastic piece on the brake that hits the Stoplight switch. If the Stoplight switch is not depress, the rear park lights (stop light) would stay on.
Your handbrake will be adjusted when you have your rear brakes adjusted by a mechanic. You can go to any brake shop and have them clean and adjust your brakes and this will fix the handbrake by doing so.
What fuse is for the 2005 Ford mustang Rear Brake lights?
To replace the broken handbrake cable on a 2003 Corsa, first lift the rear of the car and secure it on jack stands. Remove the rear wheels and brake drums to access the handbrake mechanism. Disconnect the old cable from the handbrake lever inside the car and from the brake assembly at the rear wheels. Install the new cable by reversing the disassembly steps, ensuring all connections are secure before testing the handbrake function.
To replace the handbrake cable on a VW Caddy, start by lifting the vehicle and removing the rear wheels. Detach the existing handbrake cable from the handbrake lever and the brake assembly at the rear wheels. Install the new cable by routing it through the same path, securing it to the handbrake lever and connecting it to the brake assemblies. Finally, adjust the tension of the new cable as necessary and check the handbrake functionality before lowering the vehicle.
If the rear brakes are out of adjustment,the hand brake will not work..
The Sintra has rear brake pads and disks. Inside the disks brakes are shoes for the hand brake. So yes, is does have rear shoes, but only for the handbrake.
To change the handbrake cable on a 2001 Citroën Xsara diesel, start by lifting the rear of the vehicle and removing the rear wheels for better access. Disconnect the old handbrake cable from the lever inside the car and from the rear brake assemblies. Install the new cable by routing it correctly and securing it to the lever and brake assemblies. Finally, adjust the tension of the new handbrake cable as needed and reassemble everything before testing the handbrake function.
the turn signal switch is probably bad
To replace the rear handbrake cable on a Citroën Relay, first, lift the vehicle and remove the rear wheels for better access. Disconnect the old handbrake cable from the handbrake lever in the cabin and from the brake calipers at the rear. Install the new cable by threading it through the same routing, securing it to the handbrake lever and calipers, then adjust the tension as necessary. Finally, test the handbrake to ensure it engages properly before reassembling the wheels and lowering the vehicle.
it would be the brake light switch about 20 dollars at autozone