If there is metal chips and trash from the old compressor in the system, yes you need to flush the system. Any trash left in the system will shorten the life of the new pump.
It is standard procedure to flush contamanated oil from system. if the compressor went bad . also the orfice tube.
The only reason to flush the ac system is if you had a compressor burn out. if this did not happen you just need to have the system recharged. you might have air the the system pull a vaccum on the system this should remove the air and the moisture. ******************************************************************* If you replace the compressor you should replace the drier and expansion valve and flush the system. To flush it you need a flush solution and clean dry compressed air. Put the solution in and force it out with the air one line at a time until the flush comes out clean. Install the new parts with the proper amount of oil and recharge the system.
To unseize or rebuild the AC compressor on a 2004 RX-8, you can start by attempting to free the compressor by applying penetrating oil to the pulley and rotating it manually. If the compressor is irreparably seized, you'll need to replace it, as rebuilding is often not feasible for automotive AC compressors. Ensure to replace the receiver-drier and flush the AC system to remove debris before installing a new compressor to prevent future issues. Always consider consulting a professional mechanic for a thorough assessment and proper installation.
Yes, the toilet flange should be flush with the floor when installing a toilet to ensure a proper and secure fit.
Flush the cooling system? Flush the fuel system? Flush the hydraulic brake system? Flush the AC system? Flush the transmission? Pick one.
What I do is flush the system; 'cause if your rad has corrosion, so does the rest of the cooling system. Purchase a PRESTONE flush kit at a auto store along with a container of flush and at least a gallon of antifreeze. There are detailed directions on the package. Briefly, you will be installing a flush tee in the return hose to the heater core, adding a can of flush to the rad,running the car at idle and then attaching your garden hose to do the work. Very effective.
You are best off to get a rebuilt compressor. Other parts in the compressor are probably worn also so replace the whole unit. Most suppliers won't warranty a compressor unless you change the receiver dryer at the same the & flush the system.
More than likely the metal is coming from the compressor. Replace the compressor along with the accumulator/receiver dryer and orifice tube/expansion valve. It is difficult to flush all of the metal out of the system but you must try. Any metal left in the system will eventually destroy the new compressor.
How can you flush benzos out of your system
As soon as you possibly can.
To replace the expansion valve on a 1986 Nissan 300ZX, first, locate the valve, typically near the evaporator. Disconnect the refrigerant lines and electrical connectors, then remove the mounting bolts to take out the old valve. For the condenser, drain the refrigerant, remove the mounting bolts, and disconnect the lines before installing the new condenser. Ensure to flush the system to remove any debris before reassembling and recharging the AC system.
rain buster