Yes. The main ground is to the engine block. If that main ground is disconnected, the circuit will try to find ground through smaller connections which usually ends up with the smaller grounds not big enough to carry the load of the starter and they melt.
Ground wire is loose or disconnected somewhere in that circuit.
Since a ground block is not well insulated, there's always the danger of a short.
Cherokee's are notorious for poor grounds. Start checking the ground connections from the battery to the engine block and the ground from the engine block to firewall.
Not unless it's insulated properly.
First what wires are you talking about. If you are talking about the battery cables, the power or positive cable is the one that leads to the starter or to the underhood fuse box and the ground is theone that leads to the engine block or the chasis
The function of the engine block is to hold the important components such as the cylinders and the pistons. The engine block is where combustion of fuel takes place so that power can be generated.
There is a lot of places, Just choose one that is more convenient. Just make sure that there is a direct connection to the block and not the wrong side of an engine mount. These are made of rubber and isolate the block electrically as well as mechanically. The idea really, is to get most power to the starter motor. The motor is bolted directly to the block, without insulating gaskets.
creating a greater displacement out of the stock engine block for more power
Check your Ground (negative) cable to the block. Also check the grounding of the coil to the block.
PowerNation Engine Power - 2014 Junkyard LS Long Block 1-2 was released on: USA: January 2014
PowerNation Engine Power - 2014 Junkyard LS Short Block 1-1 was released on: USA: January 2014
In the 2003 Ultra motorcycle, the main engine ground wire is typically located near the engine's mounting points, often connected to the frame or a ground terminal. It is essential for ensuring proper electrical grounding and preventing issues with the electrical system. If you're having trouble locating it, consult the service manual for specific diagrams and wiring details. Always ensure the motorcycle is off and disconnected from power before attempting any maintenance.