It doesn't have the key lock but it could easily custom installed.
I'd contact a breaker's yard, or an authorized Nissan dealer.
I need to remove my glove box on my 2009 Nissan Murano. Where are the glove box pins located?
To change the cabin filter on a 2014 Nissan Rogue, first, locate the filter compartment behind the glove box. Open the glove box and remove the dampener arm by gently pulling it off, then squeeze the sides of the glove box to lower it fully. Remove the cover of the filter compartment, take out the old filter, and insert the new one, ensuring the airflow direction matches the indicated arrows. Finally, reattach the cover, lift the glove box back into place, and reconnect the dampener arm.
To change the glove box lock on a 2007 Buick Lacrosse, first, open the glove box and remove any contents. Locate the screws or clips securing the glove box door and carefully detach it. Remove the old lock by unscrewing or unclipping it from the glove box door, then replace it with the new lock. Finally, reassemble the glove box and ensure everything is securely fastened.
To remove the glove box lock from a 2007 Mercedes ML320, first, open the glove box and locate the screws securing it. Remove these screws and gently pull the glove box out to access the lock mechanism. You may need to disconnect any electrical connectors and then unscrew or unclip the lock from its housing. Finally, carefully remove the lock from the glove box.
I don't know the answer but any glove box lock is a joke. I would just replace it but never lock it.
To lock the glove box on a Dodge Journey, locate the lock tab or latch inside the glove box. If your model has a keyhole, use the vehicle's key to turn it and lock the glove box. If there’s no keyhole, ensure the glove box is securely closed, as it typically locks automatically when the vehicle is locked. Always refer to your owner’s manual for specific instructions for your model year.
Most common problem is the BCM (Body Control Module). Located behind the glove box.
Yes, the glove box opens manually only when the key is inserted in the ignition. When you lock your car with remote you can observe the glove box key locking. So, when you lock your car, the glove box is also locked.
To fit a Citroën C3 glove box lock, first, remove the glove box by unscrewing the screws that secure it in place. Once the glove box is removed, locate the lock mechanism and disconnect any attached wiring if applicable. Install the new lock by inserting it into the designated slot and securing it with the provided screws. Finally, reattach the glove box to the dashboard, ensuring everything is properly aligned and functioning.
To remove the glove box lock on a 1971 Chevelle, first, open the glove box and locate the lock mechanism. There will typically be a retaining clip or screw securing the lock in place; remove this using the appropriate tool. Once the securing mechanism is removed, you can pull the lock out of the glove box door. If necessary, gently pry around the edges to free it completely without damaging the door.
if there is not a key hole you cannot lock it.