0
What else can I help you with?
What would happen if you put a rubber cord into an electric socket?
nothing
What is in a spark plug socket?
A spark plug socket has a rubber ring inside to hold the plug inside while it is screwed into position. The rubber ring also keeps the insulator from being damaged during installation.
How do you reach the last spark plug on Nissan Pathfinder?
you will neeed a long extension on your plug socket. but make sure you have an actual spark plug socket with the rubber insert or you will curse this job because you wont be able to pull the plug out of the hole....might be even easier with a "wobble" socket or a swivel socket..... good luck...lol
How do you replace plugs?
Usually a 5/8 deep socket with rubber "keeper"
Where is the diagnostic socket on Peugeot 307 zest?
the diagnostic socket on peugeot 307 is under the ash tray( behind the gear lever). Lift up and remove the rubber pad and there it is. Dave
How do you replace a light bulb on a 2001 cbr f4i?
just pull out the socket and the rubber boot, no tools required
What is rubber band extraction in dentistry?
Rubber band extraction is a special technique used in extraction of pt's with bleeding disorders like Haemophilia or purpura etc. it is carried out by tieing a rubber band around the socket and then carrying out the extraction procedure.
What tools would you need to remove brake pads from a 2005 Chrysler Pacifica?
1/2 socket and wrench and rubber mallet
Why is a land socket preferred to a pin socket?
The land socket uses lands rather than pins. Because it is easier to install and remove.
What size socket is used for the spark plugs in a Honda Accord 91?
From http://wiki.answers.com/Q/How_do_you_change_spark_plugs_in_a_22_liter_1990_honda_accord"Use a 5/8 or 13/16 SPARKPLUG SOCKET witchever one fits. Make sure the socket has the rubber o-ring inside so that you don't have to filch it out. "
How do you change the spark plugs on a 2001 Toyota tacoma with a 24L?
You need a six extension and a spark plug socket with a rubber stop inside. The spark plugs are located on top of the engine. They are about 4 inchs inside the head. Using the extenion put the socket with the rubber piece inside which will grip the plugs when they are unscrewed allowing you to remove the plugs. When installing use the same socket but press the plugs inside the socket so they are being gripped which will you to slowing lower them inside the head with the extension and get them started. I suggest you start them by hand.
Why is the Intel Pentium MMX Socket 7-based?
Because that's the socket Intel manufactured it for.
