0
What else can I help you with?
How do remove C12 Cat injector?
You can remove the injector, on your C 12 Caterpillar diesel engine, by removing the injector rail. Remove the retaining nut and the injector will come out.
Your '89 240 injector is leaking you tried attaching an o ring to the bottom and the top of the injector but it still leaks you compared the leaking injector to the normal injectors and you found that?
Found what? If the injector is leaking, no O Ring will fix that. Replace the injector.
On an 1990 S15 GMC is not getting fuel from the injector?
If it is just one injector, it is a bad injector or a problem in the wiring harness or connector for that injector. If it is all of the injectors, it could be a fuse, the entire injector harness, a broken loose or unplugged connector on the injector harness, or the fuel pump or fuel pressure regulator.
What is the different between power stroke injector and an injector?
alot
Where is injector solenoid on 1993 Ford F-250?
The 1993 Ford F2 50 pickup truck injector solenoid is attached to the injector fuel pump. The injector solenoid should be labeled as such.
How do you reset fuel injector?
To reset a fuel injector, first, disconnect the battery to clear any error codes. Then, remove the injector harness and inspect the injector for any damage or clogs. If necessary, clean or replace the injector, reconnect the harness, and restore power to the battery. Finally, start the engine to ensure the injector is functioning properly.
What is code P0200?
P0200 Injector Circuit Malfunction Check the connections to each injector first. Then check voltage to each injector.
In a 1987 mercury topaz why would fuel make it to the injector but not through you have good pressure and power to injector?
MIght be the injector itself.
How do you reset the fuel injector for a 1998 Chevy silverado v8?
to reset an injector , is a specialist job if injector is faulty, it needs replacing
How do you fix a injector on 99 Ford Expedition?
Replace the bad injector.
Fuel injector off and swopt it to another hole and it work for a minute and then back to problem what could be causing this a bad fuel injector or bad wires?
If the problem followed the fuel injector then it is a bad injector. If the problem stayed at the same hole with a different injector then it could be bad wiring.
What is the ohm reading on a fuel injector?
An Ohm reading is the amount of resistance through a fuel injector. A fuel injector is a solonoid that controls fuel delivery. Inside the injector, there is a coil of wire. When you measure the Ohms across the injector, you are checking the amount of resistance in that coil of wire. Each injector manufacturer has their own acceptable measurement, so check with them for proper readings.
