answersLogoWhite

0

disconnect fuel line between pump and carurettor.turn engine over. if you are getting fuel it will spurt out where you have disconnected the fuel line

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Does your 1993 Toyota pickup have a fuel pump or sending unit?

It has both.


1993 Toyota pickup doesn't seem to be getting fuel when starting cold What could be the problem?

If a 1993 Toyota is acting like it is not getting fuel in cold weather, check the fuel pressure sensor. There is also the coil and timing that might cause the car to spit and sputter in cold weather. Also check the timing belt.


Where is the fuel pump relay on a 1994 Toyota pickup?

Where is the fuel pump relay switch located on a 1994 Toyota pickup


Where is the fuel pump relay for 1993 Toyota pickup?

Under the dash, above computer. It's on a bracket that grounds to the wall. Toyota calls it a "circuit opening relay", not a fuel pump relay.


Where is the fuel pump on a 79 Toyota pickup?

The fuel pump for a 1979 Toyota Pickup is in the fuel tank. Drop the fuel tank and unbolt the fuel pump from the top for a 20R engine.


Where is the fuel filter located on a four cylinder 1995 Toyota pickup truck?

The fuel filter is located on the firewall on a four cylinder 1995 Toyota pickup truck!


Where is the fuel pump located on a 1979 Toyota SR5 pickup?

In the fuel tank.


Where is the fuel pump to 1987 Toyota pickup 4x4?

its located in the fuel tank


Where is the fuel pump in a 87 Toyota pickup?

in the gas tank


Where is fuel pump on a 94 Toyota pickup 4x4?

on the side


What is the fuel capacity of a 1993 Toyota pickup?

17 Gallon tank or 65 Liters Dims: 37" x 16" x 13 1/8"


How do you change the sending unit on 1993 Toyota pickup?

To change the sending unit on a 1993 Toyota pickup, first ensure the vehicle is turned off and disconnect the battery. Next, locate the fuel sender unit, which is typically found in the fuel tank. Remove the fuel tank and then detach the wiring harness and fuel lines from the sending unit. Finally, replace the old sending unit with the new one, reconnect everything, and reinstall the tank before reconnecting the battery.