answersLogoWhite

0

What else can I help you with?

Related Questions

What would the symptoms be for a compressor that has two cylinders and only one is pumping?

How do you fix no compression in one cylinder? Yes, a dead cylinder can be fixed by checking and rectifying any defective component that falls among some of the reasons that result in a dead cylinder; in order to fix a dead cylinder, you will have to diagnose the cylinder by using a compression gauge to test whether there are any cylinders with no compression. Usually, a leaking gasket.


What is a car misfire?

A misfire is when one of the cylinders is accelerating without actually doing anything, it's just a dead-cylinder. In order to fix this you need to tighten the cylinder or adjust the engine connector.


How do you fix a lock cylinder on a 74 nova with out the key?

you need the key to fix it.


How do you fix a master cylinder leak on a 1999 Chevy Tahoe?

Replace the master cylinder.


Fix low compression in outboard motor cylinder?

You have to take out the cylinder, how low is it, what is the difference


What cylinder would be Top dead center for 1989 jeep 4.2?

Each cylinder has a top dead center position.


How do you fix cylinder misfires?

start with new plugs


How do you fix a cylinder misfire in a Volvo?

Take it to a garage.


How can you fix cylinder block?

It would depend on what is wrong with it.


What is an engine cylinder misfire and how much does it cost to fix it?

An engine cylinder misfire is what happens when combustion is incomplete. How much it costs to fix will depend on the type of car and the year it was manufactured.


How do you fix a slave cylinder on a 1989 Jeep Wrangler?

if slave cylander is bad, it must be replaced to fix it


How do you fix a loose cylinder on a revolver?

Take it to a competent gunsmith

Trending Questions
Where can you get a wiring diagram for a chariot grandis? How long will it take to drive from Birmingham Alabama to Tuscaloosa Alabama? Does the 3 day right of rescission rule apply to a remodeling contract? Will a 1997 Vortec 350 fit properly into a 1981 Camaro Z28 The Camaro is carburated the Vortec is SFI I guess my question is will i have to make many modifications to get it to fit? How many miles are there from Topeka to Knoxville? How do you bleed your clutch on a Peugeot expert van? What is the torque on a 3800 series 2 lower and upper intake manifold bolts? Who receive the title of the great wire puller? How long does it take to drive from San Jose CA to San Diego CA? What is the fine for blocking a driveway in Torrance and can the Police tow the car immediately if homeowner can't get out? What is the distance between New Brunswick Canada and New York City? What is the distance between salford and loughborough? How much money in gas will it cost to drive 1600 miles if you get 19 miles to the gallon? How many driving miles from El Paso TX to Tucson AZ? How do you install ignition starter switch on the steering column 1988 Oldsmobile cutlass? Why was it so difficult for Kia to identify sources of defects in the cars it produced? How do you remove the staked nut on the rear spindle of a 2000 Nissan to remove the brake rotor? How do i remove the thermostat base housing on a 1984 Cadillac eldorado with a 4.1L v8 252cid engine? How long does it take to drive from Weston Super Mare to Newquay? How long does it take to drive from Glasgow to Spain?