0
To release the emergency brakes on a 1999 Chevy Venture, locate the emergency brake lever, which is typically found between the front seats. Pull the lever up slightly to disengage the tension, then press the release button at the end of the lever while pushing it down completely. Ensure the brake warning light on the dashboard turns off, indicating the emergency brake is fully released. Always check the owner's manual for specific instructions if needed.
What else can I help you with?
Why do the brakes lock up on your 2000 chev venture when you reverse?
It is possible for the brakes to lock up on a 2000 Chevy Venture when in reverse because the brakes are not working properly. Perhaps the brake pads need to be changed.
Why does your 2003 Chevy Cavalier jerk when applying the brakes?
I've got a better question, why is this question in the Chevy venture forum ?
How do you adjust the emergency brakes on a 2003 Chevy s-10?
The 2003 Chevy S 10 emergency brake can be adjusted with the emergency brake adjustment bolt. The adjustment bolt will be on the emergency brake pad.
How do you change emergency brakes 1998 Chevy calvalier?
replace the rear breaks
Frontend of your 1998 Chevy venture pulsatesshakes when brakes are applied?
It's caused by a warped brake rotor.
What are torque specs for Chevy Venture front brakes?
bolt torques for front callipers slide and mounting
Chevy Venture ABS light on?
If your Chevy Venture ABS light is on, that means that there is some type of problem with your anti-lock brakes. For the light to turn off, you will need to see a mechanic and have the problem looked at.
How do you adjust the emergency brakes on a 1996 Chevy Cavalier?
do you mean cavalier hand brake?
Where can you find a diagram of the rear brakes located on a 2001 Chevy Venture?
Best bet would be your friendly local Chevy dealer parts and service dept.
What would cause the left turn signal to flash fast when the brakes are applied at regular speed and when the brakes are disengaged on a 2000 Chevy Venture?
Usually the fuse is going bad.
How much does it cost to change the brakes on a 2001 Chevy venture?
it cost me about 15 dollars at auto zone,and it took me about 30 min to do it.
How do you release the emergency brake if the cable is broke on a 1992 Chevy s10 it is the one you push with your foot?
It depends which cable is broken. If the main cable is broken under the truck, the brakes should release on their own. If the brakes dont release, the cables are frozen from rust and need to be replaced. If the release cable from the handle to pedal assemdly is broken reach under the dash above the pedal and find the small release arm. Pull the arm toward you [ the rear of vehicle ] and the emergency brake pedal will release.
