You remove the bottom cover off the weed trimmer, and remove the tangled old wire. Insert the new wire into the side of the trimmer and wrap it around the black spindle.
To restring a Ryobi Expand-It weed eater, first remove the spool from the trimmer head. Cut a length of new trimmer line, thread it through the eyelet holes on the spool, and wind it evenly in the direction indicated on the spool. Reattach the spool to the trimmer head and trim any excess line.
To restring a Ryobi Expand-It weed eater, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert the line into the spool following the arrows for the correct winding direction. Secure the line in the notches on the spool and reassemble the spool onto the trimmer head.
To restring a Ryobi weed wacker, first, remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert one end of the line into the hole in the spool and wind it in the direction indicated on the spool until it is full. Reattach the spool to the trimmer head and feed the line through the eyelets. Your Ryobi weed wacker is now restrung and ready to use.
To restring a Ryobi weed wacker, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert the line into the spool following the arrows for direction. Wind the line evenly and tightly around the spool. Reattach the spool to the trimmer head and feed the line through the eyelets. Your Ryobi weed wacker is now restrung and ready to use.
To properly restring a Ryobi weed eater, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet. Insert one end of the line into the hole in the spool and wind it in the direction indicated on the spool until it is full. Secure the line in the notches on the spool and reassemble the spool onto the trimmer head. Cut the line to the desired length and you're ready to trim.
To restring a Ryobi string trimmer, first remove the spool from the trimmer head. Cut a length of new trimmer line, thread it through the holes in the spool, and wind it evenly around the spool. Reinsert the spool into the trimmer head, and feed the line through the trimmer head eyelets. Finally, secure the spool back in place and trim any excess line.
If it is a two-stroke then you don't. You mix the oil in the fuel and it burns it off.
with your hands...
To restring a Ryobi gas trimmer, first remove the spool from the trimmer head. Cut a length of new trimmer line, usually around 10 feet, and insert one end into the hole in the spool. Wind the line evenly and tightly around the spool in the direction indicated on the spool. Leave a few inches of line unwound, then thread the line through the eyelet on the trimmer head. Reattach the spool to the trimmer head and trim any excess line.
re string a bolens bl110
A line trimmer, also known as a string trimmer, is used to trim grass or weeds. The piece of equipment also goes by the name of a weed eater, or weed whacker.
no