To activate the passenger airbag in a Chrysler 300C, ensure that the vehicle is in the "Run" position with the engine on. Check the airbag status indicator on the dashboard; it should indicate that the airbag is enabled. If the airbag has been disabled (for example, due to a child seat in the front), you may need to adjust the settings or move the child seat to the rear for the airbag to activate. Always refer to the vehicle's owner manual for specific instructions and safety information.
Under the hood, passenger side, there is a removable grill at the base of the windshield.
I have a 2006 Chrysler 300C and my cabin filter is located passenger side under hood up by windshield, cover to lift and filter slides in. Hope this helps!
If equipped it is located under a removable screen at the passenger side base of the windshield.
If equipped it is under the hood, passenger side, under the cowl at the base of the windshield.
Pop the hood, passenger side cowl, pop out the plastic vent. No tools needed.
On the current generation it is under the hood, driver side.
The Mass Air Flow (MAF) sensor on a 2005 Chrysler 300C is located in the air intake system, specifically between the air filter and the throttle body. To access it, you'll need to remove the air intake duct that connects the air filter to the throttle body. The MAF sensor itself is usually secured with screws or clips and can be identified by its electrical connector and housing.
Bottom, front, passenger side of the engine.
Insert the ignition key into the passenger air bag on / off switch , turn the key to the on position and hold while removing key
It is on the lower, passenger side of the firewall.
In the USA you have to get permission from the NHTSA and a doctor.
It is on the passenger's side fender well under the air filter housing