There are plugs on right side. Insert ratchet and fill to level off with top plug. Then START the car. While running engine(car on jackstands) top up ontil full to filler hole on SIDE of transaxle.
how do you add transmission fluid on 98 acura cl 3.0
To add transmission fluid to a 1999 Acura CL, locate the transmission dipstick, which is usually found near the back of the engine bay, towards the driver's side. Remove the dipstick, clean it, and then use a funnel to add the appropriate type of transmission fluid through the dipstick tube. Make sure to check the fluid level after adding and run the engine briefly to circulate the fluid before checking again. Always refer to the owner’s manual for specific fluid requirements and capacity.
If it is an automatic transmission, you add transmission fluid with a long funnel through the dipstick opening.
On my '94, I went through dipstick. Make sure you get the HONDA/ACURA fluid from the dealer.
You add transmission fluid down the dipstick tube under the hood.
It is important to know where to add the proper fluids in a car. A person can add transmission fluid into the transmission dipstick tube of a 1999 Tacoma 4x4.
You add the fluid down the dipstick tube.
Add automatic transmission fluid through the dip stick tube. No kidding!
To add transmission fluid to a 2003 Acura MDX, locate the transmission dipstick tube, which is usually found near the back of the engine bay, close to the firewall on the driver's side. The dipstick is marked with a yellow or orange handle. To add fluid, use a funnel to pour the fluid into this tube, ensuring you check the fluid level with the dipstick to avoid overfilling. Always make sure to use the correct type of transmission fluid specified in the owner’s manual.
The transmission dipstick is on the front of the engine on the drivers side. This is the place to check as well as add transmission fluid.
A 1999 Toyota Camry LE will have a inlet for the transmission fluid located next to the transmission housing. Before adding fluid to the system it is important to drain the older fluid. Be sure to add the correct amount and avoid over filling the system.
To add automatic transmission fluid to a 2006 Acura TL, locate the transmission dipstick tube, which is usually found near the back of the engine bay, close to the firewall. Remove the dipstick, wipe it clean, and then insert it back into the tube to check the fluid level. To add fluid, use a funnel to pour the appropriate type of automatic transmission fluid (ATF) into the dipstick tube. Ensure the vehicle is on a level surface and the engine is warm for an accurate reading.