0
What else can I help you with?
How do you set the idle on a 1995 Yamaha 30 hp 2 stroke?
To set the idle on a 1995 Yamaha 30 hp 2-stroke outboard, first ensure the engine is warm and running. Locate the idle adjustment screw on the carburetor; turning it clockwise increases the idle speed, while turning it counterclockwise decreases it. Adjust the screw until the engine idles smoothly at the desired RPM, typically between 600-700 RPM. Finally, check for any changes in responsiveness and make minor adjustments as needed.
How much air flows through the PCV system when the engine is at idle speed?
Up to 30%
What is normal oil pressure for a 1999 Dodge Dakota?
Minimum of 10 psi at idle, 20-30 at idle is average.Minimum of 10 psi at idle, 20-30 at idle is average.
What is the normal oil pressure for 2005 Chrysler 300?
Warm engine at idle, 30-40 psi. 10 minimum.
How do you do a idle relearn procedure on a 3.2 2003 cts?
To perform an idle relearn procedure on a 2003 Cadillac CTS with a 3.2L engine, start by ensuring the vehicle is in park and the engine is at normal operating temperature. Next, let the engine idle for about 10 minutes without any load, allowing the idle speed to stabilize. After that, turn off the engine, wait for about 30 seconds, and then restart it to complete the relearn process. Finally, take the vehicle for a short drive to allow the engine control module to adapt to any changes.
Why would a 2000 Kia Sephia idle hard when the air conditioner is on but idle fine otherwise?
An A/C compressor takes about 6 horsepower to turn it and when an engine is idleing, it is producing about 30 hp so when you take away 6 hp from 30, it puts quite a load on it. There is also a device which increases the idle speed when the A/C is switched on. If this is not working or the idle is set too low then rough idle may occur.
1994 Grand Am 4cyl runs good at 30 degrees and lower but above 30 degrees engine wants to miss and stall at low idle?
Check the temperature sending unit (tells ECM what the engine temp is).
What is acceptable oil pressure for a rebuilt small block Chevy engine at idle?
Stock rebuild- it has been said that 10psi per 1000 rpm. At idle 20-30 is about right once the engine is warmed up. Of course this will also vary with the weight of the oil used-not much but it will
What is the normal oil pressure for a dodge neon?
Normal is 20-30 psi at idle. 40-60 at 3000 rpm. Minimum at idle is 10psiNormal is 20-30 psi at idle. 40-60 at 3000 rpm. Minimum at idle is 10psi
When was Idle Hands released?
Idle Hands was released on 04/30/1999.
When was Idle Hands created?
Idle Hands was created on 1999-04-30.
1994 ford ranger 4 0l xlt 5 speed manual trans when you start engine it has an adnormally high idle and takes 30-40 seconds to idle down and then when you hit the gas it does the same thing again?
Sounds like the Idle Air Control valve.
