answersLogoWhite

0

turn it to the right.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

What is 460 percent of 94?

460% of 94= 460% * 94= 4.6 * 94= 432.4


How do you change a timing belt on 1991 Ford Ranger?

how do u change a timing belt on a 94 ford ranger need help


Where is the idle control valve located on a 94 ford 460?

Right below the throttle body with a plug going to it


Will fuel injection from a 94 ford 460 fit on a older 76 ford 460?

Yes so long as you use the injected manifold as well, pirate the computer and harness from your doner vehicly you will need all the sensors.


What is the spark plug gap for a 460 cubic inch displacement for a 94 Ford F-250?

According to fordparts.com the 460 cubic inch / 7.5 liter V8 engine in a 1994 Ford F-250 has spark plugs that are gapped at ( .044 inch )


How do time a 94 Ford Escort 1.9 SEFI?

The timing is controlled by the computer and can't be adjusted.


How do you set timing on 94 ford f150 5.0?

timing should be set at 10 degrees BTDC. be sure you unplug the spout connector before you adjust the timing.


Where is the timing supposed to be for a 94' Chevy 350 with HEI ignition?

around 6-8 degrees with the vacuum advance blocked off. electronic ignition has no vacuum advance! How does one blank off the electronic advance???


What would the truck do if you had a bad timing belt on a 94 s10?

Your 94 S-10 doesn't have a timing belt.


Does a 94 Chevy Cavalier have an timing belt?

NO, it has a timing chain.


What is the ignition timing for 94 Mazda 323?

timing problem?


How do you set timing 94 festiva?

To set the timing on a 1994 Ford Festiva, first, ensure the engine is at operating temperature and disconnect the vacuum advance hose from the distributor. Use a timing light to check the timing marks on the crankshaft pulley against the timing indicator on the engine; the correct timing for the Festiva is typically around 10 degrees BTDC. Adjust the distributor by loosening the hold-down bolt and rotating it until the timing light shows the correct mark, then retighten the bolt and reconnect the vacuum hose. Always refer to your vehicle's service manual for specific details and any additional procedures.