answersLogoWhite

0

Look for bleeder valve about 1 1/2 inches tall somewhere usually front corner of engine when facing it, open small valve on top & bleed with engine at normal oper temp - usually need to open & bleed & repeat process to bleed

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the air bleed valve for the cooling system on a 2004 Chevy impala?

It is a brass fitting on the top of the thermostat housing.


Where is coolant pressure release valve for a 2004 dodge caravan?

The radiator cap controls cooling system pressure.The radiator cap controls cooling system pressure.


How do you bleed the cooling system on BMW 745Li 2004 without the bleed screw?

System is self bleeding. Just leave the radiator cap off and run. You will see the air coming out. Let car cool and then check cold level. That's it __________________


Where is the cooling fan relay located on a 2004 Dodge Intrepid?

The 2004 Dodge Intrepid cooling fan relay switch can be found on the back of the cooling fan motor. The cooling fan relay switch is attached to the fan motor with two retaining screws.


How do you bleed the clutch line on a 2004 ford ranger edge?

how do I bleed the clutch system in a 2004 ford ranger


What connects to heater core on a Dodge Durango 2004?

Usually just heater hoses-part of you cooling system which you can bypass if you have to and can't afford to fix


What the difference between a 2004 Dodge pickup with a 5.7 hemi half ton and a 2004 Dodge pickup with a 5.7 hemi three quarter ton?

The 3/4 ton has heavier axles, springs, shocks, and possibly a heavier cooling system.


What is the cooling system capacity of a 2004 Chevy Blazer with the 4.3 engine?

The 2004 Chevrolet blazer 4.3 liter engine cooling system has a capacity of 4.7 gallons. The cooling system should contain a minimum of 50 percent antifreeze.


How would you bleed cooling system on a 2004 vw bora?

To bleed the cooling system on a 2004 VW Bora, first ensure the engine is cool. Open the coolant reservoir cap and start the engine, allowing it to reach operating temperature. With the heater set to maximum, check the coolant level and add coolant as necessary. Once the thermostat opens, air bubbles may escape; continue to run the engine until the bubbles cease, then top off the coolant and replace the cap.


Put in a new thermostat and valve bleeder in 2004 Dodge Intrepid and it is still overheating what else can you do?

Make sure your cooling fans are coming on and that your water is circulating through your radiator and hoses are not clogged. You may want to try and flush your cooling system


Where can you find a diagram of the cooling system for a 2004 Chevy Duramax engine?

i need a pictrure of the cooling system diagram for 1995 Chevy suburban


Where is the cooling system on a 2004 alero?

It is in the engine compartment under the hood