answersLogoWhite

0

To change the lock cylinder on a 1996 Saturn door lock, start by removing the door panel to access the lock mechanism. Then, detach the lock cylinder by removing the retaining clip or screw, and pull the old cylinder out. Insert the new lock cylinder into the housing, secure it with the clip or screw, and reassemble the door panel. Finally, test the new lock to ensure it operates smoothly.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

Where is the slave cylinder located for a 2000 Saturn 4 door?

under the battery tray


How do deactivate the alarm on a 1996 caravan?

Put the key in any door key cylinder and turn.Put the key in any door key cylinder and turn.


What is gross vehicle weight of 1996 Saturn SC2?

Listed on the driver's door post.


Passenger door will not open from inside on a 1996 Saturn SL2?

If the door opens from the outside it may be the child safety latch. Open the door and there will be a lever on the rear of the door move this to the off position.


Free diagram of How do you remove and install a window on the driver door in a 1996 Saturn coop?

see link below


How do you change door lock barrel on xj6?

Push the spring and pull the cylinder out


How do you change the front door speakers in a 1996 Camry?

You have to remove the door panel, after that you will be able to replace the speaker.


Key in ignition chime stays on when door is opened and key not in ignition on 1999 Saturn SL2 can this be disabled?

yes it can by removing the switch located on the door trim. however this indicates the cylinder is not in the Locked position. The cylinder must be fully turn counter clock wise. If it cant a new cylinder may be needed


How do you remove the exterior window trim from the door of a 1996 Saturn SC2?

Check out this video: http://www.youtube.com/watch?v=whOOsv_EA8s


Will a sunroof motor out of a 97 Saturn. Fit in a 98 Saturn SL2?

It appears so, since The Sunroof Doctor has a replacement motor that will fit 1996- 2002 SL models Sunroof Motor 1997-2002 Saturn SC (2 & 3 Door) 1996-2002 Saturn SL (4 Door) Special! New replacement motor available at this price until our stock is gone. You reuse your original connector or hard wire to your harness $81.55


How do you change the driver's door lock cylinder on an 1987 Honda Accord?

The lock cylinder is held in by the chrome on the outside in the cylinder where the key goes in to turn it. from the inside if the door - the outer piece of the chrome (the ring) has a couple of 'fingers' that help hold it on - push it off from the inside so you can reuse it. you should be able to push the cylinder out from the door now.


How do you change door cylinder?

If it's a Euro Cylinder just unscrew the screw holding it in place, turn the key slightly until you can pull the cylinder out. Put the new cylinder in and replace the screw to hold it in place.