the same u do on a normal car
by zaid
i bought new horn for my nissan almera 5 door hatch back 1500cc and still wont work and checked fuse
32 on front and 30 0n back
on engine fire wall aka back of engine
Changing a 02 almera back light is easy for the most part. There should only be five screws that has the light in place and should have silicone around it. Use the butt of the hammer and gently put pressure on the screws which should break the seal starting at the rear first.
You can reset it but if the fault is not rectified then it will just keep coming back on.. Almeras have a glitch on there em lights caused by any little fluctuation.. There are not a plug in buld but soldered onto the circuit board, break the connection, light out....
Yes! I did this to a 1994 Nissan 4x4. But you will also have to buy the headlights and marker lights. The metal behind the grill is all the same between the pathfinder and pickup truck from back then. The only other thing you will have to do is change the plugs on the end of the wiring harness for the lights but it is really simple.
This can be done 2 ways: 1 remove the turn signal lights and remove the 3 screws holding on the lights or 2 jack up the car and remove the 3 screws from the bottom, these are at the back of the lights.
check your fuses
back of assembly and twist.
Hello, all you have to do is turn the back of the light post and pill the lights out for both the fog lamps and the break lights. For the break lights, its less work to change.
remove the 2 screws from inside the bed(if you have a bedliner you may have to pull up on the bedliner to see them) once you have those out, it should just pop out, and the lights unscrew from the back of the assembly
Two lights from the front two at the back. i wish i could change that but there you go