How do you change the wiper control module on a 2006 Ford Focus
the left kick panel on the fuse box.
The wiper control module on a 1998 Mercury Grand Marquis can be found behind the instrument panel. It is close to the steering column, on the right side.
If it is anything like a 91 Ford Tempo, then the wiper motor is on the passenger side near the vent duct for the air conditioning/heating system under the hood. There should be a plastic cover over the length of the firewall that covers the vent duct, washer fluid and the wiper motor.
The wiper control relay on your 92 BMW 325i is located in the fuse and relay panel in the engine compartment, drivers side toward the windshield. It is the long relay that is furthest away and to your right as you look down at the panel from over the driver's side fender.
I'm guessing you mean the front wiper here,- you just remove the cover over the nut and unscrew using spanner. make sure its not too loose or it will come off during motion. that's as far as i can help. THE WIPER CONTROL UNIT IS UNDER THE BLACK PANEL UNDER THE WIPERS,, TAKE OFF WIPERS AND BLACK PLASTIC PANEL CONTROL UNIT UNDERNEATH,,,,
Change this when both front and back wipers fail to work. Under the steering wheel on the left side there is a small flip out thing (I keep coins in it). If you take it out, there is a fuse panel behind it. The wiper fuse is on that panel. And on the back of the 'drawer' is the label for the panel.
The metal panel between the hood and windshield is removed to service the wiper motor.
it is on the wiper motor unplug wires unscrew cover and it pops out gos back in just the same
button on wiper control is for the wiper fluid pump,so you can squirt cleaner onto windsheid
The wiper control module is located inside the wiper motor assembly.
The wiper control module or governer is located on the passenger side up under the dashboard. Looking at the dashboard on the passenger side, look at the bottom half and you will see two screws, remove these screws and the bottom half of the dash board panel comes off. The wiper control module/relay is behind this panel to the right on a mount. Remove the mounting screw and disconnect the wiring connector, you should then be able to manipulate the module out for changing.