0
- Detach the parking brake cable from the caliper.Remove the parking brake cable bracket fastner and remove the bracket (located in front of where the lower control arm attaches to the chassis0.
- Place two floor jacks under the axle tubes to support it.
- Remove the lower control arm mounting fasteners then remove the lower arm.Discard the fasteners.
- To install the arm position it in the frame and axle mounting brackets and install new fasteners.Do not tighten fasteners at this time.
- Carefully raise the axle so that the marks on the shock absorbers line up with the dust sleeves then tighten the lower control arm mounting fasteners to 129ft-lbs.
What else can I help you with?
How do you change rear disc brakes on 2002 mustang v6?
how to change front and rear brakes on a 2003 ford mustang V-6
How do you change the rear glass in a 2002 rodeo?
Get a ford mustang
How can you change the normal rear end on your 1965 mustang to a posi traction rear end?
get a posi traction rear end and swap it out.
How do you change the rear caliper brackets on a 1999 Ford Mustang?
Buy a Honda
Where is the starter on a 1966 mustang?
Lower rear passenger side of engine, bolted to the transmission bell housing.
How much does it cost to change rear wheel drive to front wheel drive on a mustang?
6,000
How do you change the rear main seal on a 2000 ford mustang gt?
Either pull the transmission or the engine to access the rear mail seal.
Could 2001 mustang rims fit on a 2005 mustang?
yes you can same bolt pattern,..an 8.8 rear axle has'nt change since 1994
Where is the location of the starter of a 91 5.0 mustang?
Should be at the lower rear end of the engine - follow the cable from starter solenoid
Where is the radiator drain plug on a 1999 mustang?
Look at the bottom or rear bottom of the radiator or remove the lower radiator hose
Where is the PCV valve on a 1994 Ford Mustang?
The PCV on a 1994 Mustang 302 is located on the rear of the lower intake plenum. It fits into a rubber grommet and has a right-angle hose leading off of it.
Does a 2000 ford focus have a rear lower control arm?
Yes, a 2000 Ford Focus has a rear lower control arm. This component is part of the vehicle's suspension system, helping to connect the rear axle to the chassis and maintain proper wheel alignment and handling. If you're experiencing issues with the handling or alignment, it's worth inspecting the rear lower control arms for wear or damage.
