answersLogoWhite

0

drive front wheels onto ramps about150mm high to allow removal of radiator from below .remove fan cowling and hoses , fan to get room to work .undo nut on each side of radiator rubber mounting bolt.you can move the unit around enough to remove the side mount panels from the radiator and slide it out from under vehicle.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the engine oil capacity of 1998 kia pregio diesel j2 motor?

The engine oil capacity for the 1998 Kia Pregio with a J2 diesel motor is approximately 6.5 liters (or about 6.9 quarts) when including the oil filter change. It's always recommended to check the owner's manual for the most accurate specifications for your specific vehicle.


Where can you get a workshop manual for a kia pregio?

http://www.ebay.co.uk/itm/KIA-PREGIO-WORKSHOP-REPAIR-MANUAL-2004-/300919205330


What are the cylinder head torque specs and torque sequence on a Kia pregio?

the correct torque for cylinder head bolt of kia pregio 2.7 diesel is 130-135ft-lbs.


What damage can be done by non diesel fuel into a diesel Kia Pregio?

If the non diesel fuel is drained out without getting to the engine there is a good chance there wil be no damage. For more information see the answer to the Related Question shown below.


What kind of battery have a pregio?

A pregio typically refers to a type of vehicle, specifically the Kia Pregio, which is a van. The battery used in the Kia Pregio is usually a lead-acid battery, commonly a 12V type, suitable for powering the vehicle's electrical systems. Depending on the model year and engine specifications, the exact battery size and rating may vary. Always check the owner's manual or consult with a professional to ensure compatibility.


What is the Valve clearance for the 2002 kia pregio diesel j2 motor?

J2 engines are as follows Inlet: 10 or 12 thou, Exhaust: 14 thou.


What is themain and big end bearing torque for a J2 kia pregio diesel?

The main and big end bearing torque specifications for the Kia Pregio diesel engine (J2) typically range from 40 to 50 Nm (Newton-meters) for the main bearings and around 40 Nm for the big end bearings. However, it's essential to consult the specific service manual for the engine or vehicle for the exact torque values and procedures, as they may vary slightly based on the model year and engine variant. Always ensure to follow the manufacturer's guidelines for accurate and safe assembly.


Where is the engine number on a 2004 kia pregio?

On a 2004 Kia Pregio, the engine number can typically be found on the engine block itself, often located near the timing cover or on the side of the engine. It may also be stamped on a flat surface or a metal plate attached to the block. For precise location, it’s advisable to consult the vehicle's manual or a service guide.


I have white smoke blowing from my kia pregio exhaust diesel exhaust.It also mis-fires at around 2500 rpm. Does anyone have any ideas?

Hi, I have exactly the same problem. Did you ever find a solution ? Thanks Greg


What is the correct tire pressure for a Kia Pregio?

The correct tire pressure of kia pregio is 50 psi.If the ambient temperature is higher,say going above 35deg,then keep it 45psi


Where is the vin number on a kia pregio?

The VIN (Vehicle Identification Number) on a Kia Pregio can typically be found in several locations. Common spots include the driver's side dashboard, visible through the windshield, and on the driver's side door jamb. Additionally, the VIN may also be located on the vehicle's registration documents and insurance card. Always refer to the owner's manual for specific details related to your model.


Where is the kia pregio wheel jack?

Under the little front bonnet.