answersLogoWhite

0

I've changed them on my 97 4cyl, almost exact same truck, 2wd. pull off wheels,remove brake pads caliper and rotor, behind metal plate should be 4 bolts on top of ball joint and one below with cotter pin and nut, remove these. next, use ball joint seperator (fork type or auto zone loans out pro kit) to remove ball joints. install new ball joint, reassembly is reverse.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you remove the upper ball joints on a 1984 2WD Nissan pickup?

Remove wheel hub, remove the 4 bolts holding the ball joint in place, heat it up with a torch, then bash the crap out of with a hammer til the ball joint pops out.


How do you replace upper ball joint on a 98 ranger?

u can't just change the upper ball joint, u have to change the whole upper control arm. It is welded to the arm in one piece.


How do you Change upper ball joint on 2004 Chrysler town and country?

A 2004 Chrysler Town and Country does not have an upper ball joint.


Where is the thermostat located on a 1990 Nissan D21 pickup?

Look in a removable housing at the engine end of the upper radiator hose


How do you replace the upper ball joint on a 1994 Isuzu pickup?

To replace the upper ball joint on a 1994 Isuzu pickup, start by safely lifting the vehicle and removing the front wheel. Disconnect the brake line and remove any components obstructing access to the upper control arm, such as the shock absorber or sway bar link. Use a ball joint separator tool to detach the ball joint from the control arm, then remove the retaining bolts and replace the old ball joint with a new one. Reassemble the components in reverse order, ensuring everything is securely tightened.


How do you replace driver side upper Ball joint in a 1995 Lincoln Mark VII?

You have to change the upper control arm.


If you change upper ball joint should you change the lower ball joint too?

It's not always necessary to change the lower ball joint when replacing the upper ball joint. However, it's recommended to inspect the lower ball joint for any signs of wear or damage while working on the upper ball joint. If the lower ball joint shows signs of wear, it may be a good idea to replace it to ensure optimal performance and safety.


How do you change upper ball joint on a 95 S10 pick up truck 4 cylinder?

how do you change the upper and lower ball joint on a 95 s10 pick up truck 4 cylinder rear wheel drive


How do you change a upper passanger side ball joint on a 1994 Chevy silvarado 4x4?

if it is original the upper ball joint is riveted in, it will need to be chisel out,there are four rivets and then the nut that holds it to the control arm.new ball joint will come with bolts and nuts


Where is the PCV valve on a 1991 Nissan D21 Pickup 2wd?

PCV valve is located under the hood, center, upper engine area, mounted in intake manifold.


How do you take out upper ball joint from the upper arm Honda civic 1989?

what i know you can't take that ball joint to upper control arm but if you buy the upper control arm the ball joint comes with it.


How do you change CV joints on a 1995 Nissan primera?

Remove driveshaft nut,remove kingpin grease cap and remove 17mm nut.Lever down kingpin from upper arm and remove driveshaft from hub.Hammer c.v. joint off shaft( inner circlip).