If the fan runs in high but not the other speeds the resister is bad. Done.
Blown fuse, defective blower motor, or defective blower motor resistor pack.
where is resistor pack on 2010 impala lt 6 cylinder 3.5 motor
where is rear blower motor resistor on a 2001 odyssey
Check the fuses.If not the fuse, test the resistor down by the blower motor.
The blower motor resistor has failed.The blower motor resistor has failed.
Check for a blown fuse. If the fuse is good then apply 12 volts directly to the blower motor. If it runs then the Blower Motor Resistor Pack is defective. If it does not run the motor itself is defective.
Yes, a malfunctioning blower motor resistor can prevent your AC from working properly. The resistor controls the speed of the blower motor; if it fails, the blower may not operate at all or may only work at certain speeds. This means that even if the AC system is functioning, you may not get any airflow, resulting in a lack of cooling. If you're experiencing issues with your AC, checking the blower motor resistor is a good place to start.
Check to see if it getting power - if so blower is defective If not could be relay, switch or resistor
In most cases the blower motor resistor is the solution. But you need to have a repair shop check it out before you buy something that you may not need.
Check for loose wire connections also Defective blower motor or resistor pack. Blown fuse or defective blower motor switch.
If you are saying the blower motor will not work, then check the fuse. If the fuse is not blown, then it is possibly a defective Blower Motor Resistor Pack, blower motor, or blower motor speed control switch, in that order.If you are saying the blower motor will not work, then check the fuse. If the fuse is not blown, then it is possibly a defective Blower Motor Resistor Pack, blower motor, or blower motor speed control switch, in that order.
Blower motor located at the passenger side under the dash. Probably the blower motor but you need to check the blower motor resistor and the plug to the resistor. A common cause is the plug tends to melt & short out.