Disabling the keyless ignition security lock on a 2007 Saturn can be done by programming the security locks. Turn the ignition to run, without actually starting the engine, and press the unlock switch for eight seconds.
Use the key fob
theres no way to disable this feature if light is on key igintion has gone bad or going bad
If you mean in general you hit the "panic" butoon on your keyless entry. If you mean to disable completely then you need to find the fuse, I believe it is under the hood.
To reset the security system on a 2001 Saturn, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. Then, turn the ignition off and attempt to start the engine. If the issue persists, consult the owner's manual or a professional for further assistance.
To reset the security system on a Saturn Vue after changing the ignition cylinder, you typically need to perform the following steps: Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. After that, turn the key off, wait a few seconds, and then start the engine. If the security light remains on or the engine does not start, you may need to repeat the process or consult a professional for further assistance.
The Saturn dealership did all three of mine free of charge.
security to hamper theft. It prevents "smashing" the ignition cylinder to turn the steeering wheel
The location of the remote keyless entry module on a 1998 Saturn is in the rear of the passenger compartment. It is underneath the trim at about shoulder height by the right rear seat.
There are 3 different things that can cause the security lights to flash constantly on a 2002 Saturn Vue. These things are a bad passlock sensor in the ignition housing, a bad BCM, or a bad PCM.
To program a new remote keyless entry for a 2006 Saturn Ion 2, first, sit in the vehicle with all doors closed and insert the key into the ignition. Turn the key to the "On" position and then back to "Off" five times within 10 seconds, ending in the "On" position. After the locks cycle, press and hold the "Lock" and "Unlock" buttons on the remote for about 15 seconds, then release them. Finally, turn the ignition to "Off" to complete the programming process.
Passlock sensor (Ignition housing) Or body control module fault
Must be programed by a Dealer