To disconnect a Code Alarm SureStart LX, first, locate the alarm's main control unit, usually found under the dashboard or near the vehicle's fuse box. Disconnect the vehicle's battery by removing the negative terminal to prevent any electrical issues. Then, find the wiring harness connected to the alarm system and carefully unplug it. For a complete disconnection, you may also want to remove any additional sensors or sirens installed.
If it is a after-market alarm just look under the kick panel below the steering wheel. Disconnect the connectors to the alarm it should deactivate the alarm. The relay of the alarm should switch power to normal operation.
There is no single wire to disable the alarm.
Google Cause for Alarm :)
disconnect the battery for a few minutes.
If a person uses a key to unlock an alarmed vehicle, the alarm can be turned off on the 2000 Honda Civic LX by starting the car and putting it in gear. Then, put the car in park and shut the car off. Start the car again and the alarm should go off.
The alarm functions are handled by both the PCM, under the hood, and the BCM, back side of under dash fuse panel.
It can not be disabled. It is reset by unlocking as door with a key, or with the remote.
just disconnect the negatif terminal on the battery for 5 min...and then reconnect,and switch on the ignition wait till 10 sec an then start your engine..
It is the code for Swissair. http://www.airlinecodes.co.uk/airllistres.asp?airliata=L&airlicao=
Unlock the driver door with the key or use the remote.
How do you enable anti theft alarm on 1991 ford escort lx
i dont