answersLogoWhite

0

You could press in a new, oversize stud, cross drill and pin the stud, or have the head machined for screw-in studs.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Who was the inventor of press studs?

Mr press Stud


What do you call a stud horse that's been fix?

gelding


How do you change the rear stud on a 2001 Acura 3.2 CL Type S?

If by stud you mean wheel stud you have to remove the bearing and have a shop take it out or rent a press and press it out yourself because wheel studs are pressed onto the wheel bearing.


How do you fix a pressed in rocker arm stud that won't stay in?

drill a small hole through the stud boss,stud and tap a pin through both boss,stud. This is called stud pinning, you can get a kit from napa for about 20.00 bucks comes with studs,drill bit.


How do you replace a wheel stud on a kia Sophia?

Drive out the old one with a drift and a hammer and press in a new one. You can buy a new wheel stud at most auto supply stores.


Would a nose stud look good on a small slightly upturned nose?

By a fake press on and see.


How press studs work?

They consist of two components. One part has a stud and the other has a hole. When fastened, the stud fits snugly into the hole until pressure is used to force them apart to unfasten them.


How do you fix the autopilot on the aircraft on fsx?

Press Z.


how to fix a pixel art?

press ctrl-z


How do you use a Stanley stud finder to locate studs in a wall?

To use a Stanley stud finder, place it flat against the wall and press the button to turn it on. Slowly move it horizontally across the wall until it beeps or lights up, indicating a stud. Mark the location and repeat to find additional studs.


Your ipod froze and wont turn on how can you fix it?

the first thing to do is hold and press the on button for 10secnds if that does not work press and hold the on button and the middle button for 2min and that should fix your problem.


How do you use vuepoint stud finder?

To use a Vuepoint stud finder, first ensure it has fresh batteries and turn it on. Place the device flat against the wall and press the scan button to begin detecting studs. Slowly move the finder horizontally across the wall; it will signal when it detects a stud by beeping or lighting up. Once a stud is located, mark the spot for drilling or hanging items.