answersLogoWhite

0

What else can I help you with?

Related Questions

How do you install a camshaft seal in a 1988 Plymouth reliant 2.5l?

youtube that sh*t bro haha


How do you replace the rear main seal in a 1996 Plymouth Breeze?

a lot of work. the transmission has to be removed.


How do you remove the windshiewld in a 1967 Plymouth Fury?

To remove the windshield from a 1967 Plymouth Fury, start by carefully prying off the trim around the windshield using a trim tool to avoid damage. Then, use a windshield removal tool or a utility knife to cut through the sealant or adhesive holding the windshield in place. Gently push the windshield from the inside to break the seal and remove it. Ensure to wear safety glasses and take precautions to avoid injury from broken glass.


In Florida if a windshield seal is broken and leaks is it covered under the windshield law?

No, if a windshield seal is broken and leaks, it is not covered under the windshield law in Florida. You must have a cracked or broken windshield in order to be covered in this instance.


How do you remove and replace windshield on a 1999 Toyota Corolla?

To remove and replace the windshield on a 1999 Toyota Corolla, first, carefully pry off any trim pieces surrounding the windshield using a flat tool. Next, cut the adhesive seal around the windshield with a glass cutter or utility knife. Once the adhesive is cut, gently push the windshield out from the inside. To install the new windshield, apply a new adhesive sealant, set the windshield in place, and press down firmly to ensure a proper seal, then replace the trim pieces.


The windshield leaks on drivers side of car the carpet is wet even when you wash the car how would you go about fixing this?

The usual cause is a bad seal around the windshield or body rust under the seal. The windshield needs to come out and bodywork done or the seal replaced.


How do you install a windshield on a 1972 Oldsmobile cutlass convertible?

To install a windshield on a 1972 Oldsmobile Cutlass convertible, first, remove any old sealant and trim around the windshield. Clean the channel where the new windshield will sit, then apply a bead of urethane adhesive along the channel. Carefully position the new windshield in place, ensuring it fits snugly, and press it down firmly to create a good seal. Finally, reinstall any trim pieces and allow the adhesive to cure as per the manufacturer's instructions.


Passenger floorboard wet after rain Honda accord?

I would check my passenger door seal, the windshield seal, and also the drainage for the grills in the area in front of the windshield.


How can you stop rainwater from leaking through the overhead console which is above the windshield in a 2002 Chrysler Town and Country?

Your windshield seal has gone bad, using some black rtv silicone all around the top of the windshield seal will help, be sure to get it under the rubber outside part. Or, to get it done right see a windshield shop, they can re-seal your entire windshield cheaply in a little time.


How do you remove and install windshield in a 1997 mercury tracer?

Yes, you can buy at local auto parts store kit. It is simply a short thin cable with a handle on each end, you able to remove the handle and push cable under rubber seal, then re attach handle. With another person, it is a simple pull the cable back and forth around seal of windshield until free to lift out.


Should you replace a rubber seal on a front windshield when changing the windscreen?

Yes


What would cause the floorboard of a 1999 Chevrolet Silverado have standing water on the drivers side after a rain?

A leaky door seal or windshield seal