0
Un-Hook battery-
Unhook wires off old starter. (should be 3 wires ) some are 4 If unable to access wires take starter off first and then take off wires,
Unbolt starter- will slide forward towards front of vechicle- and replace new starter everything vise-versa-- Don't worry because their is No way to put it in wrong because it will only GO in (1) way.. Note: U may want to mark your wires- so that you know where to place them when you put the new starter in.
What else can I help you with?
Where is the ground wire for a Chevy 305 starter?
The Chevy starter does not have a ground wire, the starter grounds through the starter casing.
Will a 1985 Chevy 305 intake work on a 1988 Chevy 305 intake?
intake manifold is DIFFERENT for models 1985 and 1988
Will the intake from an 1985 Chevy 305 fit on a 1988 305?
yes
Will a 1985 carbarated Chevy 305 intake fit a fuel injected 1988 Chevy 305?
yes if they are both throttle body engines
What is the firing order for a 1988 Chevy Camaro?
If you have a 305 or 350, it is 1,8,4,3,6,5,7,2.
What cause your 305 Chevy engine not to start or crank?
Could be a bad battery or starter.
Where is your knock sensor and connecter at on a 1988 Chevy pick up truck with a 305 motor?
It is screwed into the passenger side of the engine block just in front of the starter. It will have an electric wire pluged into it.
What transmission is in a stock 1988 Chevy silverado with 305 engine?
Should be the 700R4
Will a 1985 305 intake manifold fit on a 1988 305 Chevy?
No. There were major engine changes between those years.
What is the point setting for a 1988 Chevy 305 engine?
Set the points for 30 degrees dwell. 1988 305 has electronic ignition.NO POINTS.last year for points was 1974
How do you change a starter for a 305 Chevy engine?
Disconnect the - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove starter mounting bolts Remove starter
Where is the Temperature sending unit located on a 1988 Chevy 305?
connected to thermostat housing
