Located in a removable housing at the engine end of the upper radiator hose Drain about 1 gallon of coolant from the radiator
Remove this housing
Make note how thermostat is installed
Clean both ssurfaces
Replace thermostat and gasket
Re-install
Re-fill coolant slowly to prevent an air lock
Start engine and look for leaks
Run engine to normal operating temperature with heater on
Re-check coolant level
Drain the radiator into a container. Remove the upper radiator hose at the engine and remove the 2 thermostat housing bolts. Remove the thermostat and clean the surfaces. Install the new thermostat,housing and bolts. Reinstall the upper hose and top off the system.
take out the bolts where the top radiator hose enters the motor,pull out thermostat,clean off gasket material on both sides,install thermostat and new gasket,tighten bolts
Drain the radiator into a container. Remove the upper radiator hose at the engine and remove the 2 bolts in the thermostat housing. Remove the thermostat and clean both surfaces. Install the new thermostat and upper hose. Top off the antifreeze.
how do you install a aftermarket radio in 1986 caprice
The thermostat on a 94 Chevy caprice classic is behind the water pump in the front center of the engine.
Drain the radiator. Remove the top radiator hose. Remove the water inlet, and take the thermostat from underneath it. Install the new thermostat. Reinstall the inlet and hose. Fill the system with coolant.
The thermostat on a 1984 ranger is located in the lower radiator hose housing connected to the engine, not the top like most vehicles..Fairly easy to replace. Just remove the bolts.. then the housing and the thermostat.
The spring side goes INTO the intake manifold.
Remove the inside door panel from your 1984 Chevy Caprice. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new exterior door handle.
How do you install a starter in a 1977 Chevrolet Caprice Classic with a 5.7 liter motor?
165-180F...
Quadrojet