0
What else can I help you with?
How to Cool a small block Chevy?
With water.
Chevy s-10 running very cool?
Replace the thermostat
Your Chevy Prizm's radiator cooling fan is running all the time even when the engine is cool why Help?
There is a good possibility the relay is stuck.
On a 1993 Chevy Lumina apv What would cause the fan to keep running after the engine is off and has been off for awhile?
Vehicle running hot? and fan trying to cool it down Bad temperature sensor?
Will running an air conditioner on fan only cost as much as running on cool?
No. Running an air conditioner on fan does not cost as much as running on cool.
Is a Chevy cool?
YES fords are junkie
How are the real cool kids on the block?
They're........ good. On second thought, they're cool.
Where is the oil filter located on a 1991 Chevy s10 v6?
ON A 91 2.8 v6 2wd, it is on the driver side of the engine block. It is a tight fit to get your hand between the exhaust and the engine, so do it when its cool.
How far can you punch out a Chevy 400 Small Block?
You are better off stroking it. The 400 has 4, and 1/8th inch bore. It also has siamese cylinders to accomodate the larger bore. And, the water does not use water to cool. It has steam holes, as the cylinders are too thin to run watrer, so, remember to have your cylinder heads drilled out for the block. To bore that motor, you would have to sleeve the cylinders, then bore them out. Very expensive.
Where is the radiator drain plug on a 2004 Chevy aveo?
the drain plug (which is plastic) is a couple of inches from the bottom of the radiator on the passenger side of the vehicle. You may have to buy a replacement plug beforehand in case it doesn't seal properly after reinstalling it. Do this when the car is cool and dont run cold water into a hot block. Also, don't leave it running after it drains (obviously!)
What kind of antifreeze to use in a 2005 Chevy Malibu classic?
Dex-Cool
Where are freeze plugs on 93 Chevy 4.3?
On a 1993 Chevy 4.3-liter V6 engine, freeze plugs (also known as core plugs or expansion plugs) are typically located on the engine block. You can find them on the sides of the block, and there may also be one or two located on the rear of the engine. Their primary function is to allow for the expansion of coolant and to prevent the engine block from cracking in the event of freezing temperatures. If you're inspecting or replacing them, ensure that the engine is cool and drained of coolant.
