i do not know go to a car stereo install ... store
should do
To connect the mute wire for your car stereo, locate the mute wire from the stereo's wiring harness, which is typically color-coded (often gray or blue). Then, connect this wire to the vehicle's ignition or a trigger source, like the accessory wire, to engage the mute function when needed. If your stereo has an external mute function, you may need to connect it to the corresponding mute control wire from the car's audio system or other devices. Always consult your stereo's manual for specific wiring instructions.
No it doesn't. The acc wire on your stereo is for accessory from your ignition switch. That's so you can turn your car key back and run your stereo without turning on the engine.
You have to buy the wiring harness for the new deck the connect the corresponding wires
No
try www.haynes.com
That would be where you connect anything with a STEREO AUDIO OUTPUT.
How do you install an after market stereo in a 1989 acura legend?
To connect a microphone to your stereo, first, ensure your stereo has a dedicated microphone input, which is often found on mixers or audio interfaces. If your stereo lacks this input, you can use a microphone preamp to boost the mic's signal before connecting it to the stereo's line input. Connect the mic to the preamp using an XLR cable, then use an appropriate cable (like RCA or 1/4-inch) to connect the preamp output to the stereo. Finally, adjust the stereo's volume and settings for optimal sound.
connect the positive and negative to the stereo
No.
http://www.installer.com/cars/chevrolet.html