answersLogoWhite

0

You should take out the Mercedes badge out of the steering wheel. Then you should see a screw inside the steering wheel. Take it out and you're done.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you remove steering wheel on Mercedes 1986 560SL?

how do you remove steering wheel on mercedes 560 SL 1987


How do you remove ignition switch on 1987 Mercedes 420sel?

To remove the ignition switch on a 1987 Mercedes 420SEL, first disconnect the battery to ensure safety. Then, remove the steering wheel and the steering column cover to access the ignition switch. Locate the ignition switch, detach any wiring harnesses, and remove the mounting screws or clips securing it in place. Finally, pull out the ignition switch and replace it as needed.


How do I remove the steering wheel of a 1987 jeep Comanche?

To remove the steering wheel of a 1987 Jeep Comanche, first disconnect the battery to avoid any electrical issues. Then, remove the horn button by gently prying it off or unscrewing it, depending on the design. Use a steering wheel puller to unscrew the central nut and pull the steering wheel off the shaft. Finally, ensure you keep track of all removed parts for reinstallation.


The ignition key stopped turning 1987 Mercedes 190 it will not unlock the steering wheel orturn to start the car?

Your ignition switch crapped on you


What does pulling knob do under steering wheel of 1987 year Honda Accord?

The knob under the steering wheel of the 1987 Honda Accord adjusts the height of the steering wheel. The knob will allow the steering wheel to move up or down.


How do you unlock steering wheel of 1987 Mercedes 420 sel without key?

You can't. Absolutely not! Call a dealership and order a new key. It's the only way.


Where do you add steering wheel fluid to a 1987 Toyota Camry?

In the steering wheel fluid reservoir, passenger side of engine. Add dextron transmission fluid to it not "steering wheel fluid"


How do you change the ignition switch in a 1987 Ford Bronco 2?

Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê


Where is the turn signal switch located on a 1987 Cutlass Ciera?

it is under the dash below the steering wheel you have to remove the steering wheel to replace it I have a manual that walks you threw this if you like I could send you the steps via email my email is braddonovan29@yahoo.com


How do you remove the steering wheel on a 1987 Ford F150?

This is for a 1995 F150 with air bag. YMMV Steering Wheel with Air Bag SPECIAL SERVICE TOOL(S) REQUIRED ³ Description ³ Tool Number ³ ³ Steering Wheel Puller ³ T77L-4220-B1 ³ Removal 1. Center front wheels (1007) to the straight-ahead position. 2. WARNING: THE BACKUP POWER SUPPLY MUST BE DISCHARGED BEFORE ANY AIR BAG COMPONENT IS SERVICED. Disconnect battery to starter relay cable (14300) for at least one minute to let the air bag backup power supply discharge. Refer to «Section 14-00». 3. Remove four air bag module retaining nuts from air bag module on back side of steering wheel (3600), and lift module away from steering wheel. 4. Disconnect air bag wire harness connector, and remove module from steering wheel. 5. Disconnect horn/speed control wire harness connector in steering wheel. 6. Remove steering wheel retaining bolt. 7. Install Steering Wheel Puller T77L-4220-B1 and remove steering wheel. Route contact assembly wire harnesses through steering wheel as steering wheel is lifted off shaft.


Where is the horn located on a 1987 Jeep wagoneer limited?

On the steering wheel


How do you remove the radio from 1987 Mercedes 300sd and a cracking noise when shute off?

how do you remove a radio from 1987 300d Mercedes also why do we get cracking sound from speakers with radio shut off.