This question is not answerable as the following is missing:
in the steering colume you must pull stering wheel to get to it
It's really easy the switch is in the steering colume.
If the dimmer control is built into the turn signal lever rather than on the floor, then the switch will be inside the left side of the steering colume.
I own a 1991 F-150 and had same problem. Check the high beam (floor) switch. That was my problem, I normally kick the switch.
If it is a tilt wheel, you will need a special tool to remove the pivot pins.
Remove the airbag and steering wheel, remove the torx screws from the steering housing and remove the housing, remove the screws from the signal and wiper switch, and remove the screws above the ignition switch and remove the switch. Replace the switch and replace everything in reverse.Ê
Disconnect the negative battery cable. Remove steering column covers Disconnect the electrical connector from the ignition switch Remove the screw retaining the switch to the steering column
its in the steering colume replace the turn signal switch
need a diagram breakdown of a 1980 chev tilt steering colume
Remove the wiring harness from the 2003 Jeep Liberty pressure switch. Remove the power steering pressure switch retaining screws. Reverse the process to install the new power steering pressure switch.
remove cover off the steering wheel maybe 4 screws look for loos or undone wires. if you have a steering colume that goes up and down they get disconneccted easy. look at your fuses.
under the steering colume