On the rear back on the left and right sides you must unscrew the bolts to remove the plastic case. Mine has a liner on the bed so I had to pry that with a crowbar to get in and unloosen the bolts. Hope this helps.
where is dash light and tail light relay on 1984 nissan pickup truck
remove s.w.cover ,remove bolt,use s. w.remover
remove the steering column cover (few screws on underside, then pop appart) unmount the bracket from arround the steering column, the ignition simply unplugs on the back.
Open the tail gate. Then look at the inside of the truck where the tail gate cables are and you will see 2 small screews, Remove them and the light will come out of the truck body.
There are two bolts inside of bed unbolt to remove taillight. Remove bulb, push down slightly and turn. Replace with new and reassemble.
first thing you need to remove the plastic cover from under the truck. there is a screw right under the radiator you might need to fell of it.
If the airbag light is flashing on a 96 Nissan truck, it is because there is a problem with the airbag circuitry. The air bag may not work properly in a crash if it is not fixed.
How do I reset the differential light on my 2006 Nissan Titan truck? Light came on while driving, and I cannot find out how to reset light.
on the brake pedal
remove the 4 10mm nuts under the plastic cover in the truck. the complete light assembly will then come off the car. then just twist socket to remove the bulb
The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.
To remove the axle from a Nissan truck, first ensure the vehicle is securely lifted and supported on jack stands. Remove the wheel and brake components, including the drum or rotor, to access the axle. Disconnect any necessary components such as the differential cover, axle bolts, and any brake lines or sensors. Finally, carefully pull the axle from the housing, ensuring to avoid damaging any seals or bearings.