0
Caution: The air control bezel uses a thin plastic overlay fixed onto an open frame. The radio bezel has locking ribs on the bottom- when removing the radio bezel, the ribs can puncture the air control bezel. Place a piece of heavy tape or carboard over the air control bezel to protect it.
Use a thin plastic tool to pry the bottom of the radio bezel until it comes loose. Then work around the sides until the bezel separates from the dashboard. Unplug the connectors at the top. It will be attached by the AC harness- remove the connector (which can be a bit tough) or just flip the bezel over the steering wheel.
Remove the three 10 mm bolts that hold the radio.
Remove the radio and unplug the connectors from the back.
GM radios are a double DIN style, so most replacements will need an install kit that will add a blank plate or storage pocket.
What else can I help you with?
Where is the aux in a 2005 Pontiac vibe?
There is no aux in on the 2005 Pontiac Vibe. There is a button the says aux but the radio in fact has no aux it.
Why does the radio not work in a Pontiac vibe?
check the fuse in the fuse box
How do you remove dash from 2006 Pontiac Vibe to change out factory radio?
To remove the dash from a 2006 Pontiac Vibe for radio replacement, start by disconnecting the negative battery cable to ensure safety. Next, use a flat-head screwdriver or trim removal tool to carefully pry off the trim panel surrounding the radio. Remove any screws securing the factory radio, and gently pull it out. Finally, disconnect the wiring harness and antenna cable from the back of the radio before installing the new unit.
How do you find the code on a Pontiac Vibe radio?
To find the code on a Pontiac Vibe radio, first, turn on the ignition and the radio. If the radio displays "LOCK" or "CODE," you will need to locate the serial number, which is usually found on the radio itself. You can often retrieve it by removing the radio from the dashboard. Once you have the serial number, you can contact a Pontiac dealership or check the owner’s manual to obtain the unlock code.
How do you replace the radio light bulb in a 2005 Pontiac Vibe?
To replace the radio light bulb in a 2005 Pontiac Vibe, first, you'll need to remove the radio from the dashboard. This typically involves using a flathead screwdriver to carefully pry off the trim panel surrounding the radio. Once the radio is out, disconnect the wiring harness and locate the light bulb socket at the back of the radio. Replace the old bulb with a new one of the same type, reassemble everything, and test the radio to ensure the light is functioning.
When was Pontiac Vibe created?
Pontiac Vibe was created in 2002.
How do you remove the center console in a 2009 Pontiac vibe or Toyota matrix?
VERY carefully....:)
How do you change starter on 2004 vibe?
Remove the positive cable from your 2004 Pontiac Vibe battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
How do you replace Pontiac vibe front wheel bearings?
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
How do you remove the brake drum from a 2005 Pontiac vibe?
http://forums.genvibe.com/zerothread?id=26369
Where is Pontiac vibe fuse box?
where is the internal fuse box on a 2008 pontiac vibe
Shifter cable for a Pontiac vibe?
Changing transmission cables on a 2006 Pontiac vibe
