should have the four menu buttons like most newer GM's. Cycle though the mileage (trip, etc) until XXX% remaining is shown and then hold down the "Check Mark" button.
how to change brake light switch in a 2007 chevy colorado
Depends on what side. On passenger side, remove air filter fixture, remove 2 top bolts for headlight, then remove well panel that's under air filter fixture. Then remove the other bolts for the head light and slide it out gently.
how to remove fuel injector plug in on a 2007 chevy suburban 5.3
Here's how to remove it. http://www.youtube.com/watch?v=hH2qZPIK7jQ
To change the rear turn signal on a 2007 Chevy Cobalt, first, open the trunk and locate the tail light assembly. Remove the screws or plastic clips holding the assembly in place, then carefully pull it out. Twist the bulb socket counterclockwise to remove it, replace the old bulb with a new one, and reassemble the tail light by reversing the steps. Ensure everything is securely fastened and test the signal to confirm it works.
is it difficult to change the fuel sensor on a 2007 Chevy Malibu
To change the daytime running light on a 2007 Chevy Tahoe, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly and gently pull it out. Disconnect the electrical connector from the back of the assembly, then replace the burnt-out bulb by twisting it counterclockwise. Reassemble everything by reversing the steps, ensuring the bulb is securely in place before securing the assembly back into the vehicle.
unscrew the light from the car, it should pop out. Twist the light bulb out and then pop the light off from the base. Reverse to reassemble.
how do i remove the dome light cover on a 2007 ford explorer suv
remove the negative cable from the battery for 10 min. reconnect it.. if its not gone take it to a mechanic
cut it out
Check the owners manual. In some models, a procedure must be done to remove the message. Example: in 2007 Chevy and up models, you must turn the key to the 'on' position (do not start the engine), and press the gas pedal to the floor 3 times to remove the "Change Oil" message.