To remove the front seat of a 1974 Duster, start by sliding the seat all the way forward to access the rear mounting bolts. Use a socket wrench to unscrew the bolts securing the seat to the floor. Once the rear bolts are removed, slide the seat back to access the front bolts and remove them as well. After all bolts are removed, carefully lift the seat out of the vehicle.
The 74 Beetle has two rails in the aft side and a sliding bar in the front center with holes for each settings of the seat adjustment. At the front of the center bar there is a clip in the front of the bar that has to be removed for the seat to slide backwards and out of the rail. The two aft legs have additional clips on the aft side of the sliding rails. Once you remove all three clips hold the seat adjustment lever and move the seat back until the front bar and the two aft legs clear the rails. That work in my 74 super beetle! Good luck.
To remove the front seats from a 1974 Super Beetle, first, slide the seat all the way forward to access the rear mounting bolts. Use a socket wrench to remove the two bolts at the back of each seat. After that, tilt the seat backward and disconnect the front mounting clips, if applicable. Finally, lift the seat out of the car, being careful to maneuver around any obstacles.
Yes it is possible remove the tranny and engine at the same time. I have done it with a 74 and a big block and tranny
NO. the child must way 90 pounds
If you are asking about separating the back from the bottom, just remove the two large screws at the base of the chrome side rails.
To change the instrument cluster on a 1974 Duster, start by disconnecting the battery to ensure safety. Remove the dashboard trim and unscrew the instrument cluster from its mounting points. Carefully disconnect the wiring harness and any gauge connections before removing the cluster. After installing the new cluster by reversing the steps, reconnect the battery and test the gauges for proper function.
1970-74 Plymouth barracuda 1971-76 dodge demon/duster/ Dart sport
Yes
THE WIRING OF THE 74 DUSTER SHOULD BE THE SAME AS THE VALIANT AND DART MAYBE EXCEPT FOR YOUR NEUTRAL SAFETY SWITCH FOR WIRING DIAGRAMS: http://www.mymopar.com/downloads/1974/74ValiantA.jpg http://www.mymopar.com/downloads/1974/74ValiantB.jpg http://www.mymopar.com/downloads/1974/74DartA.jpg http://www.mymopar.com/downloads/1974/74DartB.jpg FOR ANY OTHER QEUSTIONS ON ANYTHING MOPAR TRY: WWW.MYMOPAR.COM
68 to 74 Chevrolet Nova (Chevy II). 72 to 74 Pontiac Ventura II. 72 to 74 Oldsmobile Omega. 72 to 74 Buick Apollo. 2 door or 4 door to match your car.
VidBlogger Nation - 2011 Portland Beach Front Fun 1-74 was released on: USA: 5 September 2011
Thru 74 only. You need a 75 & up.